What to check on a Sound Signaling Device.
6 models from fike in Sound Signaling Device. Below: the full model list.
What sets sound signaling apart
Sound signaling equipment exists to answer one question other vessels cannot get from radar or AIS alone: what is this ship doing right now, in restricted visibility or during a close-quarters manoeuvre. A whistle (horn) communicates manoeuvring and warning signals under the Collision Regulations; a bell and, on larger ships, a gong communicate a vessel's status at anchor or aground. None of it is optional dress-up equipment — the required range, audibility and signal pattern are set by rule, not by the shipyard.
Read the full guide
Main components
Whistle or horn
An electrically or pneumatically driven sound-producing device, usually mounted forward on the mast or funnel, tuned to a frequency and sound pressure level set by vessel length under COLREG Annex III.
Bell
A fixed bell of a minimum diameter tied to vessel length, mounted on the forecastle, rung to signal anchoring or, historically, fog.
Gong
Required in addition to the bell on vessels 100 metres in length and over, mounted aft, used together with the bell to signal a vessel aground.
Control and power supply
A bridge-operated switch or lanyard control, with the horn's air or electrical supply arranged so it remains available even on a partial loss of ship's power.
Selection and sizing
Annex III of COLREG sets minimum audibility range and frequency band by ship length: longer vessels require lower frequency and greater audible range, because a deep, far-carrying tone is needed for a large ship's signal to be heard over its own engine and wind noise at the range at which another vessel must react. A pilot boat and a bulk carrier are not fitted with the same horn, and simply carrying a loud horn does not satisfy the rule if its frequency falls outside the band specified for the vessel's length.
Regulations and class
COLREG Rule 33 sets the carriage requirement itself: vessels 12 metres and over must carry a whistle and bell, and those 100 metres and over must additionally carry a gong of matching tone to the bell but not identical to it, so the two cannot be confused. Annex III sets the technical detail — frequency range, audibility distance and duration of blasts. Class surveys typically confirm the equipment is present, sounds correctly and that its rated audibility range has not degraded, rather than reissuing a formal type approval each time.
Typical faults
- Horn diaphragm or air supply fault — reduces sound pressure below the audible range required for the vessel's length, discovered only when tested.
- Corroded bell or gong — dulls the tone so the two become hard to distinguish, defeating the purpose of carrying both.
- Blocked or frozen air line — leaves a pneumatic horn silent exactly when restricted visibility procedures call for it.
- Bridge control fault — the horn works when tested locally but the remote bridge switch fails, which only shows up during the manoeuvring signal a pilot expects to hear.
What to look for in a supplier
- Documented sound pressure level and frequency matching the vessel's length band under Annex III, not just a generic marine horn.
- Corrosion-resistant bell and gong castings suited to the mounting location's exposure.
- Compatibility with the existing air or electrical supply run, to avoid a separate compressor or wiring change.
- A straightforward local test procedure crew can run during routine bridge equipment checks.
Test the whistle and bell together during pilot boarding preparation, not just at the annual survey — a signal that sounds fine in isolation can still be inaudible from the bridge wing over engine noise at the range a pilot boat needs to hear it.