What to check on a Jacket Water Preheater Pump.
1 models from Grundfos Marine in Jacket Water Preheater Pump. Below: the full model list.
What sets the jacket water preheater pump apart
This pump does one narrow job: it keeps jacket cooling water circulating through the main engine while the engine itself is stopped or on standby, so the block stays warm enough for an immediate start. It is not sized against the engine's running cooling load like the main jacket water pump — it only has to overcome the preheater's small circuit resistance and move enough flow to prevent stratification, so it is a fraction of the size and power of the pump it stands in for while the engine runs.
Read the full guide
Main components
Pump and motor
A small centrifugal pump, usually electric-driven and rated for continuous duty, since on a standby vessel or during long port stays it can run for days or weeks without a break.
Preheater / heater element
An electric immersion heater or a steam or thermal-oil heat exchanger raises jacket water temperature, commonly held around 60-70°C, close to normal running temperature so the engine is not thermally shocked on starting.
Non-return and isolation valves
A non-return valve stops preheated water being pushed backward through the main jacket water pump when that pump is stationary, and isolation valves let the preheater circuit be taken out of service without draining the whole jacket water system.
Thermostatic control
A local or remote thermostat cycles the heater and, on some installations, the pump itself, to hold temperature within a set band without wasting power once the target is reached.
Selection and sizing
- Flow rate matched to the preheater circuit volume, not the main cooling circuit — typically well under 10% of running jacket water flow
- Head sufficient only for the preheater loop resistance, since it never works against full engine cooling system head
- Motor rated for continuous unattended running, as this pump often operates for extended periods with no watchkeeper present
- Compatibility of materials with the same jacket water treatment chemicals used in the main system
Regulations and class
Class rules for engines intended for immediate manoeuvring readiness, and unmanned machinery space notations, require the main engine to be capable of starting from a warm condition within a defined time, which in practice makes a working preheater pump and heater a condition of holding that notation. Surveyors checking UMS or bridge control notations will confirm the preheat system reaches and holds temperature and that its failure raises an alarm.
Typical faults
- Pump seal weeping unnoticed during long idle periods — slow loss of jacket water lowers system pressure and can air-lock the circuit
- Non-return valve stuck or missing — main jacket water pump backfeeds the preheater loop when running, defeating the point of the small pump
- Heater element scaled from untreated makeup water — preheat time stretches out and trips the heater's high-temperature cutout
- Thermostat sensor drifted or fouled — engine sits well below target temperature despite the pump and heater both appearing to run normally
What to look for in a supplier
- Continuous-duty rating with documented mean time between failure for unattended running, not a general-purpose circulation pump
- Mechanical seal compatible with the vessel's jacket water treatment chemistry
- Compact footprint matching the confined space typically left for this pump in the engine room design
- Remote alarm contact for pump failure, since loss of preheating is otherwise only discovered at the next start attempt
A cold main engine that still shows a running preheat pump indication has usually lost flow through a stuck non-return valve or a burst preheater element — check jacket water temperature directly rather than trusting the running indication alone.