Boiler
A marine boiler raises steam either by burning fuel oil directly in an oil-fired unit or by recovering exhaust gas heat from the main engine in an economiser, and most vessels carry both types working into a common steam system.
What to check on a Boiler.
2 models from Parat Halvorsen in Boiler. Below: the full model list.
What Sets This Category Apart
Marine boilers split into two working principles that are often confused as one system. An oil-fired auxiliary boiler burns fuel directly to raise steam whenever the ship needs it, in port or at sea, independent of the main engine. An exhaust gas economiser instead recovers waste heat from the main engine's exhaust, producing steam for free while under way but nothing when the engine is stopped or running at low load. Most cargo ships run both into a shared steam drum or system, with the oil-fired unit picking up load in port and the economiser doing the bulk of the work at sea.
Legend
- safety valve
- steam outlet
- water level
- steam drum
- feed water
- to funnel
- furnace
- economiser
- exhaust gas in
- oil burner
Main Components
Furnace and Burner (Oil-Fired Type)
The combustion chamber and its burner assembly, with automatic flame safeguard controls that shut fuel supply on flame failure, low water level or high pressure.
Gas-Side Heating Surface (Economiser Type)
Finned tube banks arranged in the exhaust uptake, sized to extract heat without an excessive back-pressure penalty on the main engine.
Read the full guide
Steam Drum
Separates steam from water and provides the reserve volume that absorbs load swings without the water level swinging wildly.
Water Level Controls and Alarms
Independent high and low level alarms plus a low-low level shutdown, since a boiler run dry, even briefly, can warp or rupture tubes.
Safety Valves
Spring-loaded valves set to lift before design pressure is exceeded, tested and sealed at survey.
Selection and Sizing
- Steam capacity matched to the largest simultaneous demand: fuel heating, accommodation heating, tank cleaning or cargo heating on tankers
- Working pressure and superheat requirement, if any, of the connected consumers
- Economiser gas-side pressure drop kept within the main engine maker's allowable back-pressure limit
- Soot blowing arrangement for the economiser, since fouled fins lose effectiveness quickly on heavy fuel
Regulations and Class
Boilers are subject to periodic internal and external survey under class rules, with safety valve testing, water level alarm testing and, for older or higher-pressure units, thickness gauging of tubes and drums. SOLAS Ch. II-2 fire safety provisions apply to the boiler space itself, and MARPOL Annex VI governs the fuel burned in an oil-fired unit the same as it does the main engine.
Typical Faults
| Fault | Consequence |
|---|---|
| Economiser fins fouled with soot on heavy fuel operation | Falling steam output and rising exhaust back-pressure on the main engine |
| Burner flame safeguard bypassed or defeated | Unburned fuel accumulates and reignites as a furnace explosion |
| Water level gauge glass blocked or misread | Low water level missed, risking tube overheating and failure |
| Safety valve seized from infrequent lifting | Overpressure protection lost, a survey failure and genuine hazard |
What to Look for in a Supplier
- Design pressure and steam output backed by class-approved calculation, not a catalog estimate
- Economiser back-pressure figures cross-checked against the specific main engine model
- Soot blower and cleaning access designed into the unit, not added as an afterthought
Never trust a single water level indication - cross-check the gauge glass against the remote level alarm before every watch handover, because a boiler dried out by a stuck gauge glass fails suddenly and expensively.
Models in this type.
The best-documented model of each manufacturer first, then the next — 2 of 2 models in Boiler. Every row links to full specifications, documents and service notes.
Manufacturers.
All 29 manufacturers with models of Boiler. Names with a manufacturer page open it; the others open a search across the full library.
All manufacturers in the libraryAlso in Boilers.
The other equipment types in this category.
Write to us about this model — the answer comes by e-mail.
Name the make and the model and what the job is: a spare, a service call, a second opinion on a data sheet. We answer by e-mail.
No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.
Questions that come up with this equipment.
Is Boiler data free?
Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.
My model is missing — what now?
Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.
Can you source a Boiler part?
Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.