Skip to content
OceanSphereDEENPL
OceanSphereENGINES
Library› Navigation› Position & Heading› GPS Receiver
Position & Heading

GPS Receiver

A marine GPS receiver reports position only; it says nothing about heading unless paired with a second antenna for GNSS compass mode, which is why SOLAS still requires an independent, non-GNSS means of fixing position.

15models
SAILOR / Thrane & Thrane
Knowledge

What to check on a GPS Receiver.

15 models from SAILOR / Thrane & Thrane in GPS Receiver. Below: the full model list.

What sets this receiver apart from other position sources

A marine GPS receiver decodes signals from the US GPS constellation and, on most modern sets, also from GLONASS, Galileo and BeiDou, giving a fused multi-constellation fix rather than relying on GPS alone. It answers one question only: where is the antenna right now. It does not tell the bridge which way the bow points -- that is the gyrocompass's job -- and it does not replace a second, independent means of fixing position, which SOLAS still requires precisely because a single GNSS source can fail or be spoofed without warning.

GPS receiver signal path
A masthead GPS antenna receives satellite signals and feeds a receiver unit, which distributes an NMEA position output to the ECDIS, autopilot and AIS.

Legend

  1. satellite signals
  2. GPS antenna
  3. autopilot
  4. ECDIS
  5. receiver unit
  6. NMEA output
  7. AIS

Main components

Antenna

A dome-mounted active antenna with integral low-noise amplifier, positioned with a clear sky view away from radar scanners and funnel exhaust, which otherwise degrade signal-to-noise ratio.

Receiver / processing unit

Tracks 12 to 30+ satellite channels simultaneously, computes a weighted position solution, and applies differential corrections where available (SBAS such as EGNOS or WAAS, or a local DGPS beacon feed).

Read the full guide

Output interfaces

NMEA 0183 or NMEA 2000 serial output feeding ECDIS, AIS, VDR and autopilot in parallel; many bridges wire two receivers into a changeover or voting arrangement so a single antenna fault does not blind every downstream system at once.

Selection criteria

  • Number of tracked constellations and channels -- more channels shorten re-acquisition time after a mast shadow or heavy roll.
  • Update rate, typically 1 Hz for standard navigation, higher for dynamic positioning feeds.
  • Differential correction support (SBAS, RTK) where the trade requires metre-level or sub-metre accuracy, for example dredging or offshore support work.
  • Output protocol compatibility with the existing ECDIS and VDR interface list.

Regulations and class

SOLAS Chapter V requires vessels to carry a receiver for a global navigation satellite system, or terrestrial radio navigation system, appropriate to the voyage, and to maintain a means of determining position that does not depend solely on one GNSS. Class societies survey the installation as part of the navigation equipment audit rather than as a standalone item, checking that the antenna position and cabling match the approved drawing and that backup arrangements are functional.

Typical faults

  • Antenna cable corrosion at the deck gland, causing intermittent signal loss that looks like a satellite outage rather than a wiring fault.
  • Loss of differential correction when the vessel moves out of SBAS or beacon coverage, degrading accuracy without triggering an alarm on older receivers.
  • Multipath error near steel superstructure or containers, producing a stable but wrong fix that the receiver reports with high confidence.
  • Firmware not updated for GPS week-number rollover, which can jump the reported date and confuse logging systems.

What to look for in a supplier

  • Type approval certificate matching the flag state and class society of the vessel, not just a generic marine label.
  • Documented output protocol list so integration with the existing ECDIS and AIS does not need a separate converter.
  • Availability of spares and firmware updates well beyond the initial warranty period, given typical fit life of ten years or more.

Two receivers from the same manufacturer and the same antenna run are still a single point of failure if they share a mast position and a power supply -- route the second antenna and cable separately if the redundancy is meant to mean anything during a storm or a mast strike.

Would you like to know more?

One request. A person reads it and replies by e-mail.

Tell us the manufacturer, the model and what you need — a part, a service call, a second opinion. A person reads every request and replies by e-mail.

No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.

Frequently asked

Three things people ask first.

Is GPS Receiver data free?

Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.

My model is missing — what now?

Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.

Can you source a GPS Receiver part?

Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.