Skip to content
OceanSphereENGINES
Library› Navigation› Autopilot & Bridge Systems› Heading Control System
Autopilot & Bridge Systems

Heading Control System

A heading control system is the basic-mode autopilot function: it drives the steering gear to hold a set compass heading using gyro feedback and adjustable rudder gain and counter-rudder settings, without following a planned track the way a track control system does.

Hatlapa
Knowledge

What to check on a Heading Control System.

24 models from Hatlapa in Heading Control System. Below: the full model list.

What sets a heading control system apart

Within autopilot functions, heading control is the simplest mode: the system takes a heading set by the officer of the watch and drives the steering gear to hold it, correcting for yaw from wind, sea and current using feedback from the gyrocompass. It does not know or care where the ship's track lies on the chart; a track control system, by contrast, drives the ship along a planned route from the ECDIS, automatically adjusting heading at waypoints and correcting for cross-track error. Heading control is what is actually in use for most of an ocean passage even on ships fitted with track control, because it is simpler to monitor and sufficient once the ship is well clear of other traffic and hazards.

Heading control loop
Signal loop of a heading control autopilot: the gyrocompass and set-heading dial feed the control unit, which drives the steering gear and rudder using gain and counter-rudder settings, with rudder angle fed back to close the loop.

Legend

  1. gyrocompass
  2. rudder
  3. steering gear (actuator)
  4. AUTOPILOT CONTROL UNIT
  5. gain / counter-rudder settings
  6. set-heading dial
  7. rudder angle sensor
  8. feedback closes the loop
  9. rudder swings ship to the set heading (loop result)

Main components

Control unit

Takes the set heading from the operator, compares it continuously to the actual heading from the gyrocompass, and generates a rudder demand signal to correct any error.

Adaptive control parameters

Rudder gain, how much rudder is applied per degree of heading error, and counter-rudder, how early the system starts opposing the turn as the ship approaches the set heading, are tuned to the vessel's loaded condition and sea state; wrongly set, the ship either wanders off heading or oversteers into a hunting oscillation.

Read the full guide

Interface to steering gear

Sends the rudder demand to the steering gear's control system, which drives the actual hydraulic rudder actuator; the autopilot itself does not move the rudder, it commands the steering gear to do so.

Off-heading alarm

Monitors deviation from the set heading and alarms if it exceeds a set limit, a required safety function since an unmonitored autopilot can carry a ship well off course before anyone notices.

Selection and sizing

  • Compatibility with the vessel's existing gyrocompass and steering gear interface, since heading control systems are rarely a clean standalone fit on a retrofit.
  • Adaptive or self-tuning capability, which reduces the manual retuning burden as loading and sea state change through a voyage.
  • Redundancy and changeover arrangements to manual or emergency steering, tested as part of the vessel's steering gear tests.
  • Integration requirement: whether the system needs to interoperate with a track control system already fitted or planned.

Regulations and class

SOLAS Ch. V requires steering gear performance standards that heading control systems must not compromise, including the ability to revert quickly to manual steering. IMO performance standards for heading and track control systems set minimum requirements for accuracy, alarm functions and changeover behaviour. Class societies require periodic testing of the steering control system, including changeover between control modes, typically verified during the mandatory steering gear test carried out before departure and at other required intervals.

Typical faults

FaultCauseConsequence
Hunting, repeated over-correctionRudder gain and counter-rudder not retuned for a change in loading or sea stateExcess rudder activity, wasted fuel, faster steering gear wear
Slow response in following seasParameters tuned for head seas applied unchanged in a following seaLarger heading excursions before correction takes effect
Undetected drift off headingOff-heading alarm limit set too wide, or muted without being resetShip well off intended heading before the watch notices
Loss of control on changeoverPoorly tested or unclear procedure for reverting from autopilot to manual steeringDelay regaining rudder control at a critical moment, for example entering a traffic scheme

What to look for in a supplier

  • Type approval to the applicable IMO performance standard for heading, and if fitted track, control.
  • Clear, tested interface specification against the vessel's actual gyrocompass and steering gear model.
  • Documented adaptive tuning behaviour, and manual override of gain and counter-rudder for the watch officer when needed.
  • Established service support for software updates and periodic performance verification.

Retune rudder gain and counter-rudder after any significant change in loading condition or when heading into markedly different sea conditions; a setting that was smooth in ballast can hunt badly when the ship is loaded deep.

More than the data sheet shows

Write to us about this model — the answer comes by e-mail.

Name the make and the model and what the job is: a spare, a service call, a second opinion on a data sheet. We answer by e-mail.

No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.

Frequently asked

Questions that come up with this equipment.

Is Heading Control System data free?

Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.

My model is missing — what now?

Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.

Can you source a Heading Control System part?

Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.