Control Cable
A control cable carries low-power signal and command current, not propulsion or lighting load, so it is built around core count and screening rather than conductor size, and its failure shows up as a false alarm or a lost remote signal rather than a tripped breaker.
What to check on a Control Cable.
134 models from Eland Cables in Control Cable. Below: the full model list.
What sets control cable apart from power cable
Power cable is sized principally for current-carrying capacity and voltage drop over distance; control cable is sized for the number of cores it needs to carry (often a dozen or more small conductors in a single sheath) and for how well it keeps electrical noise out of a low-level signal. A control cable running between a sensor and an alarm panel, or a bridge console and a thruster control unit, typically carries only milliamps to a few amps, but a single dropped or noisy core can put a false alarm or a lost command signal into a system that looks, from the switchboard's point of view, completely healthy.
Main components
Conductors
Multiple small-gauge copper conductors, individually insulated and often colour-coded or numbered, sized by core count rather than by ampacity since the load per core is small.
Screening/shielding
An overall foil or braid screen, sometimes with individually screened pairs inside the same sheath, reduces electromagnetic interference from nearby power cables, variable frequency drives, and radio equipment picking up on the low-level signal cores.
Read the full guide
Sheath and armour
Marine control cable is typically halogen-free, flame-retardant sheathed, with braided armour common where the run passes through areas at risk of mechanical damage; unarmoured versions are used inside protected trunking or consoles.
Fire-resistant variants
For circuits that must keep functioning during a fire (emergency lighting control, fire detection loops, steering gear control), a fire-resistant construction that maintains circuit integrity for a defined period under flame is specified rather than ordinary flame-retardant cable, which only limits fire spread but is not expected to keep working while burning.
Selection and sizing
Core count with spare cores for future modification, screening type matched to the electromagnetic environment of the route (a run alongside a large VFD needs more screening than one in a quiet space), and whether the circuit falls under a fire-resistant or fire-retardant requirement are the deciding factors, well before conductor cross-section, which is usually a small standard size across the whole cable family.
Regulations and class
- IEC 60092 series marine cable standards define construction, insulation and testing for shipboard cables, including the low smoke, halogen-free requirements most flag states now mandate.
- SOLAS Ch. II-2 requires fire-resistant cabling for essential services expected to remain operational during a fire, which determines which control circuits (emergency fire pumps, watertight door control, public address) must use the fire-resistant construction rather than standard flame-retardant cable.
- Class rules on cable routing require segregation of duplicated essential control circuits so a single local fire or mechanical damage cannot disable both the main and the backup control run.
Typical faults
| Fault | Consequence |
|---|---|
| Screen not properly terminated or grounded at one end | Loss of noise immunity, showing up as intermittent false signals or erratic instrument readings under certain load conditions |
| Insulation degraded by chronic engine room heat exposure | Intermittent core-to-core or core-to-earth faults, hard to trace because they may only appear when the cable is warm or under vibration |
| Flame-retardant cable used where fire-resistant was specified | Circuit fails during the exact fire scenario it was meant to survive, discovered only during an actual emergency or a drill audit |
| Duplicated control runs routed through the same trunk | A single local damage event takes out both the main and backup control path, defeating the redundancy design intent |
What to look for in a supplier
- Cable type approval certificate referencing the correct IEC 60092 part for the construction ordered, matched against the flag state's accepted standards.
- Clear marking distinguishing fire-resistant from flame-retardant stock, since the two look similar on the reel but are not interchangeable.
- Screen and armour construction documented for the electromagnetic environment of the actual route, not a generic default.
- Sufficient spare core capacity supplied on long or hard-to-access runs, since re-pulling a control cable later is far more expensive than the extra cores would have cost at installation.
Before condemning an instrument as faulty, check the screen termination at both ends of its control cable first; a badly grounded screen produces symptoms that look exactly like a failing sensor.
Models in this type.
The best-documented model of each manufacturer first, then the next — 100 of 134 models in Control Cable. Every row links to full specifications, documents and service notes.
Manufacturers.
All 31 manufacturers with models of Control Cable. Names with a manufacturer page open it; the others open a search across the full library.
All manufacturersAlso in Cable & Wiring.
The other equipment types in this category.
One request. A person reads it and replies by e-mail.
Tell us the manufacturer, the model and what you need — a part, a service call, a second opinion. A person reads every request and replies by e-mail.
No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.
Three things people ask first.
Is Control Cable data free?
Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.
My model is missing — what now?
Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.
Can you source a Control Cable part?
Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.