Przejdź do treści
OceanSphereENGINES
Biblioteka› Engine Room› Automatyka i sterowanie› Safety System (ESD/F&G)
Automatyka i sterowanie

Safety System (ESD/F&G)

An ESD and fire and gas system exists to act faster and more consistently than a watchkeeper: it shuts down fuel and ventilation and raises alarms the moment a sensor crosses a set threshold, before a human could reach the same conclusion.

Consilium Marine
Wiedza

Co sprawdzić w Safety System (ESD/F&G).

6 modeli od Consilium Marine w Safety System (ESD/F&G). Poniżej pełna lista modeli.

What makes this type

Emergency shutdown and fire and gas systems are the layer of automation that protects the ship when something goes wrong faster than a person can respond: a gas leak in an enclosed space, a fire in machinery, or a process condition that has to be isolated immediately rather than investigated first. ESD covers the shutdown side, closing valves, tripping fuel supplies and stopping equipment, while F&G covers detection, using gas and flame sensors to trigger those shutdowns and alarms automatically. On many ships the two are integrated into one safety system logic rather than run as separate boxes, sharing sensor inputs and actuator outputs through a common controller.

ESD / fire and gas system architecture
Block diagram of a shipboard safety system showing gas and fire detectors feeding a logic solver panel, which automatically trips a fuel shutoff valve, a ventilation damper and an alarm and beacon.

Legend

  1. gas detector
  2. fuel shutoff valve
  3. ventilation damper
  4. fire detector
  5. logic solver (ESD / F&G panel)
  6. alarm and beacon

Main components

Detectors

Fixed gas detectors for combustible or toxic gas, flame detectors using UV or IR sensing, and heat or smoke detectors feed continuously into the safety system logic, positioned according to a hazardous area study rather than evenly spaced by habit.

Logic solver

A dedicated, often triple-redundant controller separate from the general automation system, since safety functions have to keep working even if the main control and monitoring system fails or is being worked on.

Przeczytaj cały przewodnik

Shutdown actuators

Emergency shutdown valves on fuel and cargo lines, ventilation dampers, and trip relays on pumps and generators, all wired to fail to a safe state on loss of power or signal, not to stay in their last position.

Alarm annunciation

Audible and visual alarms at the bridge, engine control room and locally at the affected space, with alarm prioritisation so a genuine emergency is not buried under routine process alarms.

Selection and sizing

Detector coverage and shutdown logic are engineered against a hazardous area classification and a documented cause-and-effect matrix for the specific ship, not selected from a catalogue by machinery space size. The matrix defines exactly which detector inputs trigger which shutdown outputs, and it has to be reviewed whenever equipment in the protected spaces changes, since an unreviewed matrix is a common source of gaps found at survey.

Regulations and class

  • SOLAS Chapter II-2 requires fixed fire detection and alarm systems, and separately addresses gas detection requirements for specific ship types and cargoes.
  • IACS Unified Requirements and class notations for unmanned machinery spaces set the redundancy and fail-safe requirements for shutdown logic supporting periodically unattended operation.
  • Gas carriers and tankers carry additional cargo-specific gas detection requirements under the relevant IMO codes for those ship types.
  • Class surveys test the cause-and-effect matrix directly, forcing simulated detector inputs and confirming the correct shutdown and alarm response, not just that the sensor reads correctly.

Typical faults

  • Gas detector calibration drift over time under-reports concentration, delaying an alarm until the level is already dangerous.
  • Cause-and-effect matrix left unrevised after equipment changes, so a new pump or valve is not covered by any shutdown logic.
  • Shutdown valve actuator seized from infrequent operation fails to close on demand during an actual trip.
  • Nuisance alarms from poorly positioned detectors lead crews to normalise and silence alarms, masking a genuine event later.
  • Battery or power supply backup for the logic solver not tested, leaving the safety system without ride-through capability during a blackout.

What to look for in a supplier

  • A documented, ship-specific cause-and-effect matrix delivered with the system, not a generic template.
  • Detector types matched to the actual hazards present, gas type, flame spectrum and expected fire growth rate in each space.
  • Redundancy and fail-safe design consistent with the ship's intended unmanned machinery space notation.
  • A clear process for updating the safety logic when machinery or piping is modified later in the ship's life.

Walk the cause-and-effect matrix physically against the installed sensors and valves after any machinery modification, on paper it always matches; the gaps only show up standing next to the equipment.

Modele

Modele tego typu.

Najpierw najlepiej udokumentowany model każdego producenta, potem kolejne — 6 z 6 modeli w Safety System (ESD/F&G). Każdy wiersz prowadzi do danych, dokumentów i uwag serwisowych.

Tylko Consilium Marine. Pokaż wszystkich producentów
6 modeli
Według producenta

Producenci.

Wszyscy producenci (14) z modelami Safety System (ESD/F&G). Nazwy ze stroną producenta otwierają ją; pozostałe otwierają wyszukiwanie w całej bibliotece.

Wszyscy producenci w bibliotece

Wyniki inspekcji dla tego sprzętu

Z publicznych zapisów kontroli państwa portu i US Coast Guard; przypisania do tego typu urządzeń dokonuje OceanSphere na podstawie opisów.

Podzespoły USCG

Wszystkie dane inspekcyjne i bezpieczeństwa ›

Więcej, niż pokazuje karta katalogowa

Napisz do nas o swojej maszynie — odpowiedź przyjdzie e-mailem.

Podaj producenta i model oraz czego dotyczy sprawa: część, serwis, druga opinia o karcie katalogowej. Odpowiadamy e-mailem.

Brak danych? Wystarczy zdjęcie tabliczki znamionowej lub części — dołącz je do zapytania.

Często pytane

Pytania, które pojawiają się przy tym sprzęcie.

Czy dane dla typu „Safety System (ESD/F&G)” są bezpłatne?

Tak. Każda strona modelu, każdy przewodnik i każda karta katalogowa tego typu są dostępne bez konta. Konto dodaje zapisane wyszukiwania i zapytania, niczego nie odbiera.

Brakuje mojego modelu — co teraz?

Prześlij tabliczkę znamionową. Rozpoznajemy ją ręcznie, dodajemy do biblioteki, a jeśli potrzebujesz części lub serwisu, zapytanie już u nas leży.

Czy możecie zdobyć część do Safety System (ESD/F&G)?

Tak. Podaj producenta, model i czego potrzebujesz — każde zapytanie czyta człowiek i odpowiada e-mailem.