BWMS

Electrochlorination cell

Electrolysis cells that generate hypochlorite from a side-stream of seawater passed between electrodes, with dosing pumps injecting the output into the main ballast flow.

Neutralisation dosing (electrochlorination systems)

Injects a neutralising agent, commonly sodium bisulphite, before discharge to remove residual chlorine and meet discharge water quality limits.

Control and monitoring system

Tracks UV transmittance or residual oxidant, flow rate, and treatment status, and generates the treatment record the vessel must retain for port state control.

Selection / Sizing

• Ballast pump rated flow, which sets both filter and UV/electrochlorination unit capacity in cubic metres per hour.
• Typical water quality trading pattern: high-turbidity coastal or riverine ballasting favours a robust filter and can push UV dose requirements up sharply.
• Salinity range: electrochlorination output depends on the salinity of the side-stream, and low-salinity or freshwater ballasting needs a system rated for that, or a brine injection option.
• Power availability, since UV systems draw significant electrical load at full flow and electrochlorination adds cell and dosing pump load.
• Holding tank capacity if the filter backwash cannot be discharged directly at the operating location.

Regulations / Class

Any BWMS installed to meet the IMO BWM Convention must carry BWMS Code type approval, and ships trading to US waters need separate USCG type approval since UV dose and electrochlorination residual testing protocols differ between the two regimes. Discharge must meet the D-2 performance standard, and electrochlorination systems have an additional discharge limit on total residual oxidant that neutralisation dosing is there to satisfy. Class societies require the treatment and bypass piping arrangement, along with sampling points for port state control, to match the approved system drawings.

Typical faults

What to look for in a supplier

• Type approval test data covering the ship's actual trading water quality range, particularly turbidity and salinity extremes.
• Filter mesh size and backwash frequency matched to the expected sediment load, not a generic default.
• Service network for lamp, sleeve and cell replacement, since these are the parts with defined service lives and the most common cause of downtime.
• Clear commissioning support to establish baseline UV transmittance or cell output figures for later trend monitoring.

Keep a running log of filter differential pressure and UV transmittance readings from day one; a system drifting toward failure to treat almost always shows it in these trends weeks before an alarm or a port state sample catches it.