Liferaft Launching Equipment
Liferaft launching equipment covers the davits, falls and release gear that lower a liferaft under control to the water, as distinct from a throw-over raft that simply free-floats off, and the choice between the two depends on freeboard and ship type.
What to check on a Liferaft Launching Equipment.
1 models from VIKING Life-Saving in Liferaft Launching Equipment. Below: the full model list.
What sets liferaft launching equipment apart
Not every liferaft is simply thrown over the side. On ships with significant freeboard, or where SOLAS requires it based on the vessel's arrangement, liferafts are lowered under control using a purpose-built davit system, similar in principle to a lifeboat davit but lighter, since a liferaft container plus occupants is a fraction of a lifeboat's weight. This matters because a raft dropped from height onto water can be damaged on impact or blown away from the ship before anyone boards it; a davit-launched system lands the raft gently alongside and lets people board it at or near deck level in some arrangements before lowering.
Legend
- davit head sheave
- davit arm
- falls (wire rope)
- hook with remote release
- painter line
- liferaft canister
- cradle
- sea level
Main components
Davit arm
A single-arm or radial davit swings the raft container out over the ship's side, sized for the raft's stowed weight, not the loaded weight, since the raft inflates and is boarded after launching or during lowering depending on the arrangement.
Falls and winch
Wire or fibre falls run through the davit head to a winch that lowers the raft under control; the winch normally has a hand-crank backup for power failure.
Read the full guide
Hydrostatic release unit
Fitted to the raft's painter line so the raft releases automatically and inflates if the ship sinks before anyone can launch it manually, a requirement independent of whether the raft is davit-launched or throw-over.
Painter line and inflation trigger
The painter connects the raft to the ship and triggers the CO2 inflation system when pulled out to its full length, whether the raft was thrown or lowered.
Selection and sizing
- Freeboard: the deciding factor for whether SOLAS requires davit launching rather than allowing a simple throw-over arrangement.
- Raft capacity and container weight: sets the davit's load rating and the winch's lowering speed control range.
- Number of stations: matched to total persons on board split across the required number of survival craft positions, with the usual port and starboard redundancy.
Regulations and class
SOLAS Chapter III sets out when davit-launched liferafts are required as opposed to throw-over rafts, based largely on the height of the embarkation deck above the waterline. The IMO LSA Code covers the davit, winch and release gear construction standards. Class surveys check the hydrostatic release unit's expiry date, since these units have a fixed service life and are one of the most commonly found overdue items at survey, along with load testing of the davit and winch at prescribed intervals.
Typical faults
| Fault | Consequence |
|---|---|
| Expired hydrostatic release unit | Raft may fail to release automatically if the ship sinks before manual launch |
| Winch brake wear or corrosion | Uncontrolled lowering speed, risk of raft hitting the water hard or the falls running out |
| Davit arm corrosion at the pivot | Arm will not swing out under manual effort when power is lost |
| Painter line chafed or incorrectly led | Fails to trigger inflation, or triggers it prematurely in the stowage |
What to look for in a supplier
- LSA Code type approval for the complete davit and winch assembly, matched to the raft weight it will actually launch.
- Clear service intervals and load test documentation for the winch and falls.
- Compatible hydrostatic release units with published expiry tracking, not a generic unit bought separately without confirmed compatibility.
Track hydrostatic release unit expiry dates on the same schedule as the liferaft's own service date, not separately — these are the two most common overdue findings at a lifesaving appliance survey and they rarely expire on the same day.
Models in this type.
The best-documented model of each manufacturer first, then the next — 1 of 1 models in Liferaft Launching Equipment. Every row links to full specifications, documents and service notes.
Manufacturers.
All 2 manufacturers with models of Liferaft Launching Equipment. Names with a manufacturer page open it; the others open a search across the full library.
All manufacturers in the libraryAlso in Accommodation & Access Equipment.
The other equipment types in this category.
Write to us about this model — the answer comes by e-mail.
Name the make and the model and what the job is: a spare, a service call, a second opinion on a data sheet. We answer by e-mail.
No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.
Questions that come up with this equipment.
Is Liferaft Launching Equipment data free?
Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.
My model is missing — what now?
Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.
Can you source a Liferaft Launching Equipment part?
Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.