Skip to content
OceanSphereENGINES
Library› Engine Room› Steering Gear› Steering Control System
Steering Gear

Steering Control System

The steering control system is the electronics between the wheel or autopilot and the hydraulic power unit it does not move the rudder itself, and a fault here can leave a perfectly healthy steering gear unresponsive, which is why NFU, FU and autopilot signal paths are tested and documented separately from the gear's hydraulics.

Data Hidrolik
Knowledge

What to check on a Steering Control System.

1 models from Data Hidrolik in Steering Control System. Below: the full model list.

What the steering control system covers, and what it does not

Steering gear the rams, pumps and rudder actuator generates the physical force that turns the rudder stock. The steering control system is the layer above it: the wheel, non-follow-up (NFU) levers, follow-up (FU) wheel, and autopilot interface that tell the hydraulic power unit which way to move and by how much. A vessel can have fully functional hydraulics and still be unable to steer if the control signal path fails, which is exactly why SOLAS treats the two as separate systems requiring separate redundancy: at least two independent steering control systems operable from the bridge, each able to command the same steering gear through an independent signal path.

Steering control system signal path
Block diagram of the steering control unit taking commands from the steering wheel, autopilot and NFU lever, sending solenoid signals to the hydraulic power unit, receiving rudder position feedback and driving the rudder angle indicator.

Legend

  1. steering wheel
  2. rudder feedback unit
  3. autopilot
  4. steering control unit
  5. NFU lever
  6. hydraulic power unit (solenoid valves)
  7. rudder angle indicator

Main components

Follow-up (FU) control

Takes a wheel or tiller input and commands the rudder to match that angle proportionally, using a feedback signal from a rudder angle transmitter to know when the commanded angle has been reached. This is the normal steering mode for manual helm.

Non-follow-up (NFU) control

A simple port/starboard lever that runs the rudder in the commanded direction for as long as it is held, with no automatic stop at a target angle the helmsman watches the rudder angle indicator and releases the lever manually. NFU is the required independent backup mode if the FU system fails.

Read the full guide

Autopilot interface

Accepts a heading or track command from the autopilot computer and translates it into rudder orders, typically through the same signal path as FU control, with a hard changeover to manual steering available at all times.

Rudder angle transmitter and indicator

A separate feedback device, often duplicated, that reports actual rudder position back to the control system and to the rudder angle indicators on the bridge and in the steering gear compartment the only way to confirm the rudder is actually where it has been commanded to go.

Selection and sizing

  • Number of independent control systems required matches the vessel's steering gear redundancy class, commonly two systems for a main steering gear arrangement with duplicated power units.
  • Signal path independence separate cabling, power supplies and, where required, separate control stands, so a single fault cannot disable both systems together.
  • Compatibility with the specific steering gear's power unit interface, since control systems are rarely interchangeable across different hydraulic actuator makes without modification.
  • Changeover time between control systems, which SOLAS requires to be achievable within seconds from the bridge.

Regulations and class

SOLAS Chapter II-1 requires that loss of any single steering control system does not leave the vessel without a means of steering, and mandates a changeover switch on the bridge that moves control to the alternative system without delay. Emergency steering, operable locally from the steering gear compartment without any bridge control system at all, is a further mandatory fallback and must be drilled and logged periodically. Class surveys test the changeover between systems and the emergency steering drill as part of the annual and periodical steering gear examination, not just a static inspection of the equipment.

Typical faults

FaultCauseConsequence
Rudder does not respond to wheelSignal fault in FU control path, control card failureLoss of steering in primary mode, must change over to NFU or backup
Rudder angle indicator disagrees with actual positionRudder angle transmitter drift or feedback linkage wearHelmsman steers to a false indication, risk of over-correction
Autopilot hunts or oscillatesGain settings not matched to sea state or loaded conditionExcessive rudder activity, fuel penalty, gear wear
Changeover switch fails to transfer controlCorroded contacts or unmaintained switch mechanismDelay in restoring steering during a control system fault

What to look for in a supplier

  • Documented compatibility with the vessel's existing steering gear power unit and rudder angle transmitter.
  • Genuinely independent second control path, not two control panels sharing the same signal cable or power supply.
  • Spare parts and diagnostic support for the specific control cards or modules fitted, which vary significantly between makers.
  • Commissioning test records showing an actual changeover and emergency steering drill, not only a bench test.

Drill the changeover to the second control system and to emergency steering at the same interval, not just the one written into the checklist an emergency steering drill nobody has actually run in months is the failure mode this whole redundant arrangement exists to prevent.

Models

Models in this type.

The best-documented model of each manufacturer first, then the next — 1 of 1 models in Steering Control System. Every row links to full specifications, documents and service notes.

Showing only Data Hidrolik. Show all manufacturers
Related types

Also in Steering Gear.

The other equipment types in this category.

Ram Type Steering GearRam-Type Steering GearRotary Vane Steering GearSteering Gear
More than the data sheet shows

Write to us about this model — the answer comes by e-mail.

Name the make and the model and what the job is: a spare, a service call, a second opinion on a data sheet. We answer by e-mail.

No details at hand? A photo of the rating plate or the part is enough — simply attach it to the request.

Frequently asked

Questions that come up with this equipment.

Is Steering Control System data free?

Yes. Every model page, every guide and every datasheet for this type is readable without an account. An account adds saved searches and requests, nothing is taken away.

My model is missing — what now?

Send us the nameplate. We identify it by hand, add it to the library, and if you need a part or a service, the request is already on our desk.

Can you source a Steering Control System part?

Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.