MAB Series
The MAB series (Marine Automatic Bowl) was Alfa Laval's entry-level model for smaller vessels, fishing trawlers and yachts from the 1970s onwards. Compact design with semi-hermetic bowl design, simple operation. Production discontinued around 2000, but still in use on thousands of small vessels worldwide. Successor is the P-Flex series. Spare parts supply almost exclusively through third-party suppliers.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Paring disc, top disc, mud ports check for dull spots/wash-out; erosion depth >0.2 mm (bowl/cap) or >0.5 mm (other) = replacement.
Leaks at cover/bolted joints/mud outlet; gasket rings (EPDM) change every 6000–8000 h, original parts only.
Check vibration/noise; bearings change in pairs every 12000–16000 h, lubricate correctly; do not increase throughput during vibration.
Belts every 3000 h (tension per manufacturer), cracks/wear; coupling check for axial play (>0.5 mm = fault), corrosion.
Monitor current consumption nominal/actual; clean bowl during shutdown; check pre-filtration + lubrication; limit sludge volume.
Type-general inspection and maintenance points for this equipment category — not model-specific.
Service & Maintenance
Bowl overhaul every 3,000-5,000 hrs. Very compact, accessible for onboard maintenance. Motor bearing replacement at 15,000-20,000 hrs.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →