"> DESMI Cargo DSLP-200/100m crude
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
DESMI Cargo

DSLP-200/100m crude

DESMI Cargo DSLP-200/100m crude — Tanker Cargo Systems. The supplied category identifies the equipment as Submerged Cargo Pump, and it is normally installed in a cargo tank, pump well or cargo pump room with connections to the vessel cargo piping and control system. In that listed role, its primary purpose is to load, discharge, circulate or strip liquid cargo according to the vessel cargo arrangement. Submerged, deepwell and pump-room centrifugal designs differ in drive, shafting, sealing and tank interface, so the listed model must be checked against the cargo-system drawings. The model designation identifies the listed configuration, but no additional performance, approval or construction detail is inferred from the model code beyond the information supplied in the source record. For exact ratings, dimensions, settings, capacities, materials and variant-specific limits, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

flow rate m3h 200
head m 100
cargo type crude
material SS316

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Bearing, shaft or guide wear causes vibration, abnormal noise, reduced efficiency or mechanical contact
Tank-top, shaft or mechanical seal leakage causes visible cargo leakage, vapour release or contamination of adjacent systems
Hydraulic, electric or mechanical drive faults cause reduced speed, inability to start or protective trips
Impeller or pump-stage fouling, erosion or damage causes low discharge pressure and reduced cargo rate
Dry running, poor suction or inadequate tank level causes overheating, vibration or accelerated wear

Service & Maintenance

Inspect seals, drive system, bearings, shaft condition where accessible, vibration, discharge behaviour and leakage. Confirm stripping and minimum-liquid operating practices follow the approved cargo procedure. Review hydraulic oil, motor or gearbox condition as applicable. Refer to the manufacturer documentation for the exact figure for clearances, minimum levels and wear limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry seal kits, bearings or bushings where approved for onboard work, hydraulic or electrical drive spares, gaskets and critical pump-stage components identified by the manufacturer.
Equipment Model #93979 · ✓ still in production