"> RWO Veolia FU-15
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
RWO Veolia

FU-15

RWO Veolia FU-15 is identified in the source list as a freshwater generator or watermaker. It is normally installed in the engine room or utility machinery space and connected to seawater intake, product-water, reject or brine and treatment systems. Its purpose is to produce freshwater from seawater for domestic or technical use by the process used in the installed unit. The existing database record provides no additional model-specific operating figure beyond the listed designation and category. The category does not establish whether this exact model uses evaporation, reverse osmosis or another process, so the treatment principle must be confirmed from the manufacturer documentation. The exact model designation identifies the installed process and capacity; do not infer production rate or treatment technology unless stated in the source or manufacturer documentation.

Components & Design

Component data being added…

Technical Data

capacity t day 15
process vacuum distillation
energy source waste heat
salinity ppm out 2

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Reduced production caused by fouled heat-transfer surfaces, membranes or filters, resulting in lower product-water output
Poor product-water quality caused by membrane damage, carry-over, salinity-cell faults or process imbalance, resulting in high-salinity alarms or rejected water
Feed or ejector performance loss caused by clogged strainers, pump wear or seawater restriction, resulting in inadequate flow or vacuum
Scaling or biological fouling caused by unsuitable feedwater conditions or inadequate treatment, resulting in rising pressure drop or reduced capacity
Valve, seal or piping leakage caused by corrosion or wear, resulting in seawater leakage, loss of vacuum or unstable operation

Service & Maintenance

Trend product-water quantity and quality together with relevant pressures, temperatures or vacuum indications for the installed process. Maintain seawater strainers, filters and treatment chemicals or cleaning routines as specified for the unit. Inspect pumps, ejectors, membranes or evaporator surfaces as applicable and investigate any abrupt change in salinity. Clean and preserve the system using only procedures compatible with the installed materials. Verify automatic product-water diversion or rejection arrangements after maintenance. Refer to manufacturer documentation for exact cleaning criteria, water-quality limits and operating conditions.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep filter elements, seals, gaskets, salinity or conductivity sensor service parts, pump seals and model-specific treatment components. Membrane elements, evaporator plates or ejector nozzles may be strategic spares depending on the actual process and vessel endurance. Confirm exact materials and parts from the unit documentation.
Equipment Model #70127 · ✓ still in production