"> Pieralisi Pieralisi FP 1200 SL 2000l/h sludge
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for Pieralisi in the Maritime Network Find suppliers →
Is Pieralisi your company? Claim this page
Pieralisi

Pieralisi FP 1200 SL 2000l/h sludge

Pieralisi Pieralisi FP 1200 SL 2000l/h sludge is identified in the source list as a sludge separator. It is normally installed or arranged in the engine-room bilge, sludge, fuel or lubricating-oil treatment area. Its purpose is to separate oil, water and solids according to the listed process. The source record provides no additional model-specific operating figure beyond the listed designation and category. The equipment is based on rotating bowl or separation vessel, feed, discharge and controls. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

Pieralisi Pieralisi FP 1200 SL 2000l/h sludge

Components & Design

Component data being added…

Technical Data

separator type sludge_separator
throughput lh 2000
medium sludge
bowl speed rpm 7500

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Mechanical wear caused by inadequate lubrication, contamination or long service, resulting in rising vibration, noise or temperature
●Seal or gasket deterioration caused by wear, corrosion or misalignment, resulting in visible leakage or loss of process containment
●Flow restriction, cavitation or fouling caused by blocked passages or unsuitable operating conditions, resulting in reduced capacity and unstable performance
●Motor, coupling or drive failure caused by electrical faults, misalignment or overload, resulting in trips, abnormal current or inability to reach normal speed
●Sensor, control or protection failure caused by wiring, calibration or electronics faults, resulting in alarms, incorrect control response or shutdown

Service & Maintenance

Inspect bearings, lubrication, seals, couplings, foundations, process connections and protective devices. Trend vibration, temperature, pressure, flow and motor load where available and investigate deterioration from the established normal condition. Check for leakage, corrosion, fouling and abnormal mechanical contact. Function-test local and remote controls, alarms and shutdowns after maintenance. Maintain cleanliness during opening and reassembly. Refer to the manufacturer documentation for the exact figure for clearances, limits, settings and overhaul criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep model-correct seals, gaskets, bearings, filters or strainers, coupling parts, sensors and manufacturer-recommended wear components. Critical installations may justify a rotating assembly, motor or control module according to redundancy. Confirm all parts against the exact model and serial number.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Pieralisi?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #79886 · ✓ still in production