"> SWEP SWEP B80 Series
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 4 verified suppliers & service companies for SWEP in the Maritime Network Find suppliers →
Is SWEP your company? Claim this page
SWEP

SWEP B80 Series

SWEP SWEP B80 Series is identified in the source list as a brazed plate heat exchanger. It is normally installed as a compact component within refrigeration, HVAC, freshwater, oil or auxiliary cooling and heating circuits. Its purpose is to transfer heat between two separated fluid circuits through a compact corrugated plate pack. The existing database record provides no additional model-specific operating figure beyond the listed designation and category. Unlike an openable gasketed plate exchanger, the plate pack is permanently brazed and is generally serviced by external cleaning or replacement rather than plate-by-plate overhaul onboard. The exact series designation identifies a particular plate size and connection arrangement; capacity and material selection must be confirmed from manufacturer documentation.

SWEP SWEP B80 Series

Components & Design

Component data being added…

Technical Data

hx type brazed_plate_heat_exchanger

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Internal fouling caused by scale, sludge or degraded fluid, resulting in reduced heat transfer and increased pressure drop
●Channel blockage caused by debris entering narrow passages, resulting in restricted flow and abnormal differential pressure
●Internal corrosion or braze failure caused by incompatible media or damaging operating conditions, resulting in cross-contamination or pressure loss
●External connection leakage caused by damaged joints or piping stress, resulting in visible fluid loss
●Fatigue damage caused by repeated hydraulic or thermal shock, resulting in progressive leakage or loss of integrity

Service & Maintenance

Trend temperatures and pressure drop and maintain effective upstream filtration. Use only cleaning methods and chemicals compatible with the exchanger materials. Inspect all external connections and supports for leakage, corrosion and piping loads. Avoid rapid valve movement, water hammer and severe thermal cycling. Investigate any evidence of cross-contamination between circuits. Refer to the manufacturer documentation for exact operating limits, cleaning procedures and pressure-test criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep connection seals or gaskets where fitted, filtration consumables and service parts for associated valves and instrumentation. The brazed core is normally replaced as a complete unit if it develops an internal structural leak. For critical non-redundant duty, consider a complete spare exchanger.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for SWEP?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #79002 · ✓ still in production