"> SWEP SWEP B25 200kW FW cooling
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 4 verified suppliers & service companies for SWEP in the Maritime Network Find suppliers →
Is SWEP your company? Claim this page
SWEP

SWEP B25 200kW FW cooling

SWEP SWEP B25 200kW FW cooling is a shipboard unit in the Heat Exchangers group, classified in the source as Brazed Plate Heat Exchanger. It is normally installed in engine-room cooling, heating, fuel, lube-oil, HVAC or freshwater circuits. Its primary duty is to transfer heat between two fluid circuits without intentionally mixing them. In service it interfaces with piping, isolation valves, pumps, temperature/pressure sensors and the connected cooling or heating systems. Compared with neighboring entries in the same product family, this record is the exact SWEP SWEP B25 200kW FW cooling variant; the model designation should be retained unchanged when matching onboard documentation and spares. For exact limits, settings, test values and approved maintenance criteria, refer to the manufacturer documentation for the exact figure.

SWEP SWEP B25 200kW FW cooling

Components & Design

Component data being added…

Technical Data

hx type brazed_plate_heat_exchanger
capacity kw 200
material stainless_steel_316

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Plate/tube fouling from scale, sludge or marine growth, typically indicated by reduced temperature approach, high pressure drop or insufficient cooling/heating
●Gasket or braze leakage from ageing, chemical attack or thermal stress, typically indicated by external leakage or cross-contamination
●Corrosion/erosion of heat-transfer surfaces, typically indicated by fluid contamination, pinhole leakage or loss of performance
●Flow blockage or air locking, typically indicated by unstable temperatures or reduced flow
●Incorrect tightening or mechanical distortion after maintenance, typically indicated by gasket leakage or uneven plate compression

Service & Maintenance

Inspect for leakage, fouling, corrosion and abnormal pressure drop; clean heat-transfer surfaces using approved methods, inspect gaskets and verify connected strainers and flow conditions; exact tightening dimensions and test pressures come from manufacturer documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep approved gasket sets for plate units, sealing materials, vent/drain fittings and replacement plates or service kits according to criticality.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for SWEP?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #78989 · ✓ still in production