"> Volcano (Bono) Volcano MAC 15t/10bar
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for Volcano (Bono) in the Maritime Network Find suppliers →
Is Volcano (Bono) your company? Claim this page
Volcano (Bono)

Volcano MAC 15t/10bar

Volcano (Bono) Volcano MAC 15t/10bar — HFO/MDO. It is normally installed in the engine room or boiler space with connections to fuel or exhaust heat, feedwater, steam and safety systems. Its primary purpose is to generate steam for heating, fuel treatment, tank service and other shipboard consumers. Fired, exhaust-gas and composite variants differ mainly in heat source and burner arrangement; the exact configuration must follow the installed documentation. The model designation identifies the listed configuration, but no additional meaning is inferred from the model code beyond the information supplied in the source record. For exact ratings, dimensions, settings, capacities, materials and variant-specific limits, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

boiler type auxiliary_oil-fired_boiler
steam capacity th 15
design pressure bar 10
fuel type HFO/MDO

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Burner or heat-source faults reduce steam production and cause flame, temperature or pressure alarms
●Feedwater-control or level-sensing faults cause unstable water level, low-level trips or abnormal feed-pump cycling
●Soot, scale or internal deposits reduce heat transfer and cause poor steaming performance or abnormal temperatures
●Tube, coil, gasket or valve leakage causes visible water, steam or fuel leakage and pressure loss
●Control, fan, flame-monitoring or safety-device faults cause repeated trips or failure of the normal operating sequence

Service & Maintenance

Inspect pressure parts, burner or exhaust-heating section, water-level devices, feedwater system, safety valves and controls. Review water treatment, leakage, deposits and alarm history. Function-test protective devices under the approved procedure. Refer to the manufacturer documentation for the exact figure for pressure, temperature, burner and wear limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry burner and ignition parts where applicable, filters, valve and pump seal kits, level-control parts, gaskets, control relays and manufacturer-approved pressure-part consumables.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Volcano (Bono)?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #78206 · ✓ still in production