"> MaxxSilence MSP-1000-35dB
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Is MaxxSilence your company? Claim this page
MaxxSilence

MSP-1000-35dB

MaxxSilence MSP-1000-35dB is identified in the source list as a marine exhaust silencer. It is installed in the exhaust-gas piping between the engine or generator and the funnel outlet, with structural supports and expansion arrangements appropriate to the exhaust system. Its purpose is to reduce exhaust-noise transmission while allowing engine exhaust gas to pass with acceptable system resistance. The source record provides no additional model-specific operating figure beyond the listed designation and category. The internal acoustic elements, casing, insulation, drainage and connection geometry are selected for the installed engine and exhaust arrangement. The exact model designation and any attenuation value contained in the source name distinguish acoustic duty and physical size from neighboring silencers; refer to the manufacturer documentation for the exact figures.

Components & Design

Component data being added…

Technical Data

noise reduction db 35
max exhaust temp c 600
diameter mm 1000
back pressure mbar 35

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Internal baffle or acoustic-element damage caused by vibration, thermal cycling or corrosion, resulting in rattling, increased noise or rising exhaust resistance
●Casing corrosion or cracking caused by condensate, salt contamination or thermal stress, resulting in exhaust leakage or soot staining
●Insulation deterioration caused by water ingress or heat damage, resulting in hot external surfaces and damaged lagging
●Drain blockage caused by soot or corrosion products, resulting in condensate accumulation and accelerated internal corrosion
●Support or expansion-joint failure caused by vibration or pipe growth, resulting in misalignment, cracking or abnormal load on the silencer connections

Service & Maintenance

Inspect casing, supports, flexible joints, insulation and drain arrangements for leakage, corrosion and heat damage. Listen for internal rattling and compare exhaust noise and backpressure indications with the vessel's established normal condition where monitored. Keep condensate drains clear and repair damaged insulation promptly. Inspect adjacent piping and supports for thermal-growth or vibration problems that can load the silencer. Do not modify internal elements without manufacturer approval because acoustic performance and backpressure are linked to the design. Refer to manufacturer and engine documentation for exact permissible backpressure and repair criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep gaskets, flexible-joint components where applicable, drain fittings, insulation materials and mounting hardware recommended for the installation. Large internal acoustic elements or complete silencers are normally strategic spares rather than routine onboard stock. Verify replacement dimensions and engine compatibility from the approved exhaust-system documentation.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for MaxxSilence?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #72109 · ✓ still in production