DVMX
Flowserve DVMX — Multistage axially split between bearings centrifugal pump for marine high-pressure fluid transfer and ballast services.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Visual inspection for seawater corrosion and salt deposits on casing and exposed surfaces
Bearing temperature monitoring and lubrication level verification
Mechanical seal condition assessment for leakage (normal maximum 40-60 drops per minute)
Vibration analysis at baseline RPM with comparison to spectral baseline for misalignment or bearing wear detection
Coupling alignment check (parallel within 0.0254mm TIR, outside diameter within 0.0762mm TIR)
Impeller clearance verification to casing cutwater (approximately 3mm) for proper priming
Shaft straightness inspection (maximum TIR not exceeding 0.05mm at sleeve and coupling journals)
Suction and discharge strainer inspection and cleaning to prevent cavitation
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →