3+1SVL130

Typowe problemy

• Rod packing leakage from hydrogen's small molecule size making it more prone to permeate through seals than air or nitrogen
• Suction/discharge valve plate fatigue cracking or spring failure from pulsating gas flow, particularly on the recycle cylinder
• Crosshead/crankcase lube oil contamination from process gas migrating past the distance-piece packing
• Piston ring and rider band wear accelerated by high differential pressure across stages
• Intercooler/aftercooler tube fouling on the cooling water side, reducing discharge temperature margin
• Distance-piece purge (nitrogen) flow interruption or blockage, undermining the crankcase/process gas separation
• Pressure packing case overheating at the high-pressure stage under sustained full-load running

Lista kontrolna przeglądu

• Verify distance-piece purge gas flow and pressure against manufacturer's setpoint before every start
• Log rod packing leak-off rate at each running-hours interval and trend against baseline
• Inspect suction/discharge valve assemblies for plate cracking, seat wear, and spring fatigue
• Check crosshead guide and pin clearances against maker's tolerance
• Monitor cylinder and crankcase vibration levels against baseline
• Confirm hydrogen gas detection around the compressor skid and vent stack is in test and calibrated
• Inspect intercooler/aftercooler tube bundles for fouling and verify approach temperature
• Confirm relief valve set pressures and test certificates are current

Interwały serwisowe

Typowe granice zużycia

Zakresy są typowe dla tej klasy konstrukcyjnej. Decydujące są zawsze dokumenty producenta dla danego numeru seryjnego.

Krytyczne części zamienne

• Rod packing ring sets (per stage)
• Suction and discharge valve assemblies/plates
• Piston rings and rider bands
• Crosshead pin and bushing
• Distance-piece purge seals
• Pressure relief valves
• Crankcase lube oil filters

Bezpieczeństwo

• Hydrogen leakage - a small, highly diffusive gas that permeates seals and fittings more readily than air; gas detection and enclosure ventilation must be confirmed before entry and before start-up
• High-pressure process gas piping (up to roughly 137 bar per the rated data) - stored-energy hazard during any maintenance requiring depressurisation
• Crankcase overpressure/explosion risk if hydrogen migrates past the packing - purge system integrity is safety-critical, not routine housekeeping
• Hot surfaces at cylinder heads and high-pressure discharge piping
• Static discharge/ignition control near hydrogen vent points and purge outlets

Przegląd klasyfikacyjny

Note on source data: this unit is catalogued under 'Air Compressor' / 'Air Compressors', but the manufacturer data describes a reciprocating hydrogen (H2) make-up/recycle gas compressor (3 make-up + 1 recycle cylinder, up to ~137 bar) - not a shipboard starting/service air compressor. The content above addresses the actual hydrogen gas compressor service. For gas-fuelled or hydrogen-carrying installations, expect Continuous Survey Machinery treatment covering gas detection function tests, purge system verification, relief valve testing, and packing leak-off trend records as recurring survey items.

Szacowana trwałość: Wear parts (valves, packing) are condition-renewed items; the compressor frame itself, on well-maintained duty, is commonly expected to reach on the order of 80,000-120,000+ running hours before a major overhaul - confirm against Neuman & Esser documentation for this specific unit.