"> Carboline Carbozinc 85% ZP
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 5 verified suppliers & service companies for Carboline in the Maritime Network Find suppliers →
Carboline

Carbozinc 85% ZP

Carboline Carbozinc 85% ZP is listed in the source as a marine Epoxy Primer within the Paint & Coating Systems group. Equipment of this type is typically installed on the hull, decks, superstructure, tanks or machinery-space surfaces specified by the vessel's coating schedule. Its primary duty is corrosion, fouling, chemical or fire-protection service associated with the Epoxy Primer, and it provides protection only when surface preparation, compatible coating layers, film build, curing and environmental conditions follow the approved coating system. Neighboring variants can differ in rating, size, interface, approval basis or arrangement, so the complete model designation and actual nameplate data are important for identification. It normally interfaces with the prepared substrate, compatible primers or topcoats, sealants and the vessel's inspection and maintenance coating records. For any exact capacity, pressure, voltage, tolerance, wear limit or setting not stated in the source, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

product line Carbozinc
coating type zinc_rich_primer
zinc content pct 85
application method airless spray
dft micron 75
voc g l 340

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Poor adhesion caused by inadequate surface preparation, contamination or incompatible layers can appear as peeling, blistering or flaking
Underfilm corrosion caused by coating damage, salts or moisture can show as rust staining, blistering or localized breakdown
Cracking or premature wear caused by excessive film build, movement or mechanical abrasion can expose the substrate
Curing defects caused by unsuitable temperature, humidity or mixing can leave soft, tacky or uneven coating
Chemical or ultraviolet degradation outside the coating's intended service can cause chalking, discoloration, loss of gloss or erosion

Service & Maintenance

Inspect coating continuity, adhesion defects, rusting, blistering, cracking and mechanical damage, and identify the underlying substrate condition before repair. Confirm surface preparation, product compatibility and curing requirements from the approved coating specification. Refer to manufacturer documentation for exact mixing ratios, film thicknesses, overcoating intervals and environmental limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep only correctly identified and in-date coating products, compatible thinners or cleaners where specified, surface-preparation consumables and application equipment appropriate to the approved vessel coating system.
Equipment Model #142118 · ✓ still in production