"> ALMAC Marine ALMAC Marine Stern Ramp 300t 18m-C
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 11 verified suppliers & service companies for ALMAC Marine in the Maritime Network Find suppliers →
Is ALMAC Marine your company? Claim this page
ALMAC Marine

ALMAC Marine Stern Ramp 300t 18m-C

ALMAC Marine ALMAC Marine Stern Ramp 300t 18m-C is identified in the source list as a stern ramp. It is structurally integrated with a vehicle deck, cargo hold or hull opening and connected to the vessel's lifting, hydraulic or securing arrangements. Its purpose is to open, close, support or provide access to cargo spaces while maintaining the structural, weather or water integrity required for the installation. The source record provides no additional model-specific operating figure beyond the listed designation and category. Panels, ramps or doors are combined with hinges, rollers, tracks, hydraulic or electric drives, locking devices, seals, controls and interlocks. The exact model designation and any source-listed load or size distinguish the arrangement from neighboring cargo-access equipment; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

capacity t 300
width m 18

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Hydraulic leakage or actuator failure caused by hose, cylinder, pump or valve faults, resulting in slow, uneven or unavailable movement
●Hinge, roller, bearing or pin wear caused by cyclic loading and corrosion, resulting in play, noise or misalignment
●Locking-device or interlock failure caused by wear, contamination or sensor faults, resulting in inability to secure the opening or persistent alarms
●Seal deterioration caused by compression set, damage or contamination, resulting in water ingress or failure of the required closing condition
●Structural cracking or deformation caused by impact, overload or fatigue, resulting in visible distortion or survey findings

Service & Maintenance

Inspect hinges, rollers, pins, bearings, hydraulic equipment, locking devices, seals, controls, foundations and high-load structural areas. Function-test limit switches, position indication, interlocks and emergency stopping arrangements with the operating area clear. Check hydraulic hoses and cylinders or electric drives according to the installed design. Examine structural welds for corrosion, cracking or impact damage. Verify all locks are fully engaged and the required closing indication is obtained before sea passage. Refer to the manufacturer documentation for the exact figure for inspection intervals, test loads, closing criteria and wear limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep seals, hydraulic hoses or cylinder service parts where applicable, limit switches, sensors, locking-device consumables, rollers, bearings and manufacturer-recommended drive components. Critical structural and locking parts must match the approved system. Heavy panels and ramp assemblies are normally strategic spares.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for ALMAC Marine?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #139478 · ✓ still in production