"> TTS Marine TTS Marine Stern Ramp 50t 16m-C
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
TTS Marine

TTS Marine Stern Ramp 50t 16m-C

TTS Marine TTS Marine Stern Ramp 50t 16m-C is a shipboard unit in the RoRo Equipment group, classified in the source as Stern Ramp. It is normally installed at the vessel's stern, side or internal vehicle decks where ramps and watertight/weathertight doors provide cargo access. Its primary duty is to open, close and support safe vehicle or cargo access while maintaining the required structural and watertight integrity when secured. In service it interfaces with hydraulic power units, cylinders or winches, hinges, locking devices, seals, limit switches, local/remote controls and ship structure. Compared with neighboring entries in the same product family, this record is the exact TTS Marine TTS Marine Stern Ramp 50t 16m-C variant; the model designation should be retained unchanged when matching onboard documentation and spares. For exact limits, settings, test values and approved maintenance criteria, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

capacity t 50
width m 16

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Hydraulic leakage from hoses, seals or cylinders, typically indicated by slow movement, pressure loss or visible oil leakage
Hinge, bearing or wire/chain wear from high loads and corrosion, typically indicated by jerky movement, abnormal noise or misalignment
Locking device or cleat malfunction from wear or poor adjustment, typically indicated by failed secured indication or inability to achieve full closure
Seal damage or compression loss from ageing and mechanical damage, typically indicated by water ingress or failed hose/watertightness test
Limit switch or control fault, typically indicated by incorrect open/closed indication, interlock failure or interrupted movement

Service & Maintenance

Inspect structural members, hinges, wires/chains, cylinders, hydraulic leaks, locking devices, seals, drainage, limit switches and indication/interlocks; verify emergency operating arrangements and test closure according to approved procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry seal sections, hydraulic hose/oring kits, limit switches, solenoid valves, locking-device wear parts and critical control components appropriate to the installed ramp or door.
Equipment Model #139151 · ✓ still in production