"> Observator Hs-10 Tanker
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 6 verified suppliers & service companies for Observator in the Maritime Network Find suppliers →
Is Observator your company? Claim this page
Observator

Hs-10 Tanker

Observator Hs-10 Tanker is identified in the source list as a magnetic compass. It is installed on the bridge and/or at the associated sensor location, with outputs distributed to other navigation equipment as required by the vessel. Its purpose is to provide the navigation measurement indicated by the equipment category for bridge use and connected systems. The source record provides the existing record note 'Position & Heading'. Sensor principle, correction methods, interfaces and redundancy depend on the exact model and vessel installation. The exact model designation distinguishes sensing technology, display functions and interfaces from neighboring navigation instruments; refer to the approved manufacturer documentation for the exact figures.

Components & Design

Component data being added…

Technical Data

imo compliant True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Sensor or antenna fault caused by fouling, damage, wear or water ingress, resulting in loss, weak response or degraded navigation data
●Power-supply failure caused by breaker, converter or wiring problems, resulting in loss of indication
●Processor or display fault caused by electronics or software problems, resulting in frozen, blank or erroneous output
●Interface or network failure caused by cabling or configuration faults, resulting in missing data at connected bridge equipment
●Calibration, alignment or configuration error caused by incorrect setup or maintenance, resulting in persistent disagreement with independent navigation references

Service & Maintenance

Compare the indicated value with independent references and investigate persistent disagreement rather than applying unrecorded corrections. Inspect sensors, antennas, transducers, cabling, power supplies, repeaters and network interfaces applicable to the installed equipment. Verify alarms and data outputs to radar, ECDIS, autopilot and voyage-data systems where connected. Keep calibration, deviation or configuration records current as appropriate to the sensor type. Protect exposed sensors and transducers from paint, deposits and water ingress. Refer to manufacturer and bridge-equipment documentation for exact test, calibration and alignment procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep fuses, lamps or display consumables, selected power-supply and interface modules, cables or connectors and manufacturer-recommended sensor service parts. Replacement core sensors, antennas or processors must remain compatible with the approved bridge installation. Preserve calibration and configuration data when changing equipment.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Observator?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #135778 · ✓ still in production