"> ENWA Marine UV-10 Marine
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 31 verified suppliers & service companies for ENWA Marine in the Maritime Network Find suppliers →
Is ENWA Marine your company? Claim this page
ENWA Marine

UV-10 Marine

ENWA Marine UV-10 Marine is a UV sterilizer in the supplied category 'Water Treatment / UV Sterilizer'. It is normally installed in the freshwater treatment or distribution system. It is intended to disinfect water by exposing the flowing stream to ultraviolet radiation. Compared with neighbouring entries in the same series, the supplied data identifies this variant by the source-listed characteristic 10 m³/h capacity. In service it interfaces with feedwater piping, pretreatment or strainers, pumps, product-water line, reject or drain connections and control instrumentation. Model-specific limits, settings, dimensions and acceptance criteria that are not stated in the supplied data should be taken from the manufacturer documentation.

Components & Design

Component data being added…

Technical Data

capacity m3h 10
treatment type UV Sterilization
uv dose mj cm2 40

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Fouling or scaling of heat-transfer surfaces, membranes or UV components reduces output or treatment effectiveness
●Feed-pump wear or restricted strainers reduces flow and causes low-pressure or low-production alarms
●Seal, hose or piping leakage causes loss of pressure and visible water leakage
●Sensor or conductivity-monitor faults can reject acceptable product or permit unreliable quality indication
●Control-valve or electrical faults can interrupt automatic sequencing and stop production

Service & Maintenance

Trend production rate and product-water quality, inspect feed strainers, pumps, valves, seals and the treatment element appropriate to the technology. Clean or replace membranes, heat-transfer surfaces or UV lamps only by approved procedures and verify alarms and automatic diversion or shutdown functions. Exact chemical-cleaning limits, pressures and water-quality criteria must follow manufacturer and vessel documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Typical spares include prefilter elements, pump seals, O-rings, conductivity or flow-sensor service parts and the technology-specific consumables such as membranes or UV lamps recommended by the manufacturer.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for ENWA Marine?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #113363 · ✓ still in production