"> SAACKE IG Generator 5000m3h O2<0.5% flue gas
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for SAACKE in the Maritime Network Find suppliers →
Is SAACKE your company? Claim this page
SAACKE

IG Generator 5000m3h O2<0.5% flue gas

SAACKE IG Generator 5000m3h O2<0.5% flue gas is identified in the source list as a flue gas inert gas generator. It is installed in the tanker inert-gas or nitrogen plant and connected to the cargo-tank gas distribution system. Its purpose is to generate, clean or condition low-oxygen gas for cargo-tank inerting and atmosphere control according to the installed process. The source record provides the existing record note '5000 m³/h capacity'. Gas-generation, scrubbing or membrane or PSA stages, blowers, valves, analyzers, drying and control interlocks form the process according to the exact design. The exact model designation distinguishes gas capacity, process method and purity from neighboring inert-gas or nitrogen units; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

capacity m3h 5000
o2 content percent 0.5
dew point c -20
ig type flue gas

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Scrubber, membrane or adsorber performance loss caused by fouling, contamination or media deterioration, resulting in poor gas quality or reduced output
●Fan, compressor or blower failure caused by bearing, motor or impeller problems, resulting in low inert-gas pressure or loss of supply
●Analyzer or sensor drift caused by contamination or calibration faults, resulting in unreliable oxygen or process readings
●Valve or seal leakage caused by corrosion and wear, resulting in loss of gas containment or incorrect system routing
●Control, regeneration or drying failure caused by electrical, heating or sequencing faults, resulting in high moisture, poor purity or protective shutdown

Service & Maintenance

Inspect process vessels, scrubbers, membranes or adsorbers, fans or compressors, valves, analyzers and pressure-control equipment. Remove soot or deposits and maintain free drainage where wet gas treatment is used. Verify oxygen or process analyzers using the approved calibration method and keep sampling lines clean. Function-test alarms, automatic shutdowns and deck-isolation arrangements as required by vessel procedures. Inspect corrosion-prone wet sections and pressure vessels closely. Refer to the manufacturer documentation for the exact figure for oxygen, purity, pressure, temperature and maintenance limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep filter or demister elements, fan or compressor seals and bearings, valve service kits, analyzer cells or sensors, gaskets and manufacturer-recommended control spares. Membrane or adsorbent replacement should follow the exact process design. Confirm materials are compatible with the installed gas service.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for SAACKE?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #98196 · ✓ still in production