OceanSphereFree accountLog inDEENPL
OceanSphereENGINES
Library› Electrical› Cable & Wiring› Power Cable (0.6/1 kV)› Eland Cables MGCH 4Cx185mm2 0.6/1kV SWA

MGCH 4Cx185mm2 0.6/1kV SWA

Power Cable (0.6/1 kV) · Cable & Wiring

Class-certified type (DNV register) · technical data sheet not yet verified

Eland Cables MGCH 4Cx185mm2 0.6/1kV SWA — 185 mm² cross-section.

Specifications

Technical data.reference — unverified

Do you have the manufacturer datasheet for this model? Send it with the enquiry form — we check it and name the source.

Cross Section (mm²)185
Voltage Class0.6/1kV
Cores4
MaterialCu
InsulationXLPE
Fire RatingIEC60332-1
Halogen-FreeYes
ArmorSWA
Inspection

Inspector Detail

Common issues

  • Insulation resistance degradation from moisture ingress at glands or termination points
  • Armour wire (SWA) corrosion where gland bonding is missing or degraded
  • Mechanical damage to the outer sheath from chafing against trays or penetrations
  • Overheating/discolouration at terminations from under-torqued or oversized lugs
  • Water tracking into a gland that has been incorrectly fitted

Inspection checklist

  • Visual inspection of the outer sheath for cuts, abrasion, or heat/UV degradation
  • Insulation resistance test conductor-to-conductor and conductor-to-armour
  • Check gland integrity and armour bonding/earth continuity at each termination
  • Inspect cable support/tray fixings for security and chafe protection
  • Verify termination lug torque against the manufacturer's table
  • Confirm routing is clear of hot surfaces and that fire-rated penetrations are properly sealed

Service intervals

Insulation resistance testannually, or per class survey cycle for essential circuits
Visual inspection of sheath, glands and supportsevery 6-12 months
Termination torque checkat commissioning and after any disturbance

Typical wear limits

Insulation resistance, 0.6/1kV power cablegenerally expected well above the applicable minimum (commonly quoted around 1 M-ohm as an absolute floor) - a declining trend across surveys matters more than a single reading
Sheath/jacket damage before repair is requiredany breach exposing armour or insulation in a wet or hazardous area should be treated as needing repair or replacement, not left in service

Ranges are typical for this design class. Always confirm against the manufacturer documentation for your serial number.

Critical spares

  • Armoured cable gland set, correct size and thread
  • Crimp/compression lugs for 185 mm2 conductor
  • Repair length of the same cross-section and voltage class
  • Heat-shrink or cold-shrink termination kit

Safety

  • Working on or near energised power cables without verified isolation
  • Armour continuity faults can leave exposed metalwork live under fault conditions
  • Damaged insulation on 0.6/1kV cable is a shock hazard in wet spaces

Class survey

Surveyors check cable sizing against the load calculation, insulation resistance test records, fire-rated penetration sealing at bulkhead/deck crossings, and correct segregation from other services. Essential-circuit cables are usually covered under the electrical periodic survey rather than continuous survey.

Estimated lifetime: Fixed marine SWA/XLPE power cables of this type are typically designed for 20-25+ years of service in a properly installed and protected run; actual life is governed by installation conditions (heat, chafe, UV, flexing) rather than by operating hours

Need this part?

Request a quote for this model.

Free of charge — send us your request for Eland Cables equipment. Our team checks it and replies by e-mail.

Makers and authorised dealers rarely quote marine equipment without the vessel. With these details we can check availability and prices faster; without them we may have to ask first, which can cost a few days. If you cannot share the vessel, a photo of the equipment’s rating plate does the same job — attach it below or send it as a reply to our confirmation e-mail.

Your contact details are not published. No account required.
Related models

Also in Power Cable (0.6/1 kV).

Other models of the same equipment type, Eland Cables first.

By manufacturer Draka/PrysmianPrysmianHelkama BicaNexansLS CableEland CablesNKT MarineTMC MarineTKF/TKDUNIKAStuder CablesSEIMIElettrotek KabelTMC CableAmerCableAll manufacturersSpare parts by equipmentNew here? Create a free account Can't read the plate? Try the nameplate scanner All Eland Cables models More like MGCH 4Cx185mm2 0.6/1kV SWA
Would you like to know more?

A person reads every request and replies by e-mail.

Tell us what you need for this Eland Cables MGCH 4Cx185mm2 0.6/1kV SWA — a part, a service call, a second opinion. Are you Eland Cables? Claim this brand page.

Service engineer? Write the day report for this MGCH 4Cx185mm2 0.6/1kV SWA in OceanSphere Work — photos, hours and parts, as a PDF for the owner. Try it free for 14 days →

Frequently asked

Three things people ask first.

Is this model's data free?

Yes. Specifications, documents and service notes for this model are readable without an account. An account adds saved searches and requests, nothing is taken away.

Can you find a part for this exact model?

Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.

The specifications look wrong — what now?

Send us the nameplate or the correct value. We check it against the manufacturer datasheet or class-society record and update the page.