"> Hi Fuji Hi Fuji FDS 10 1000l/h HFO
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Hi Fuji

Hi Fuji FDS 10 1000l/h HFO

Hi Fuji Hi Fuji FDS 10 1000l/h HFO is a shipboard unit in the Separators & Purifiers group, classified in the source as Fuel Oil Separator. It is normally installed in the engine room or purifier room close to fuel, lube-oil or bilge treatment systems. Its primary duty is to separate water and solid contaminants from oil or oily water using centrifugal or separator processes appropriate to the service. In service it interfaces with feed pumps, heaters where fitted, sludge discharge, clean-oil outlets, water connections, controls and alarm systems. Compared with neighboring entries in the same product family, this record is the exact Hi Fuji Hi Fuji FDS 10 1000l/h HFO variant; the model designation should be retained unchanged when matching onboard documentation and spares. For exact limits, settings, test values and approved maintenance criteria, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

separator type fuel_oil_separator
throughput lh 1000
medium HFO
bowl speed rpm 7500

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Bowl or disc-stack fouling from sludge accumulation, typically indicated by reduced separation efficiency, vibration or frequent discharge
Seal or O-ring deterioration, typically indicated by oil/water leakage, loss of operating water or unstable separation
Bearing/spindle wear from poor lubrication or imbalance, typically indicated by vibration, noise or high-temperature alarms
Incorrect interface control or water-seal condition, typically indicated by oil in water outlet, water in clean oil or repeated alarms
Control/solenoid or discharge mechanism fault, typically indicated by failure to discharge sludge or repeated shutdown

Service & Maintenance

Inspect bowl/disc components, seals, spindle/bearings, operating-water passages, feed temperature/condition, vibration and alarm history; use manufacturer documentation for exact bowl speeds, clearances and service limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep complete seal kits, bowl O-rings, operating-water solenoid parts, bearings/service kits, feed-pump seals and critical control sensors.
Equipment Model #79942 · ✓ still in production