"> Pieralisi Pieralisi FP 2500 5000l/h HFO
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 1 verified suppliers & service companies for Pieralisi in the Maritime Network Find suppliers →
Is Pieralisi your company? Claim this page
Pieralisi

Pieralisi FP 2500 5000l/h HFO

Pieralisi Pieralisi FP 2500 5000l/h HFO is identified in the source list as a fuel oil separator. It is installed in the engine-room fuel, lubricating-oil or sludge-treatment area with feed, heating, clean-liquid, sludge and control connections appropriate to the process. Its purpose is to use centrifugal force to separate water and solid contamination from fuel or lubricating oil, or to concentrate sludge according to the category. The source record provides no additional model-specific operating figure beyond the listed designation and category. A high-speed rotating bowl, disc stack or sludge space, feed and discharge passages and operating-water or control system form the separator. The exact model designation distinguishes bowl size, throughput and automation arrangement from neighboring purifiers; refer to the manufacturer documentation for the exact figure.

Pieralisi Pieralisi FP 2500 5000l/h HFO

Components & Design

Component data being added…

Technical Data

separator type fuel_oil_separator
throughput lh 5000
medium HFO
bowl speed rpm 6500

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Bowl fouling or sludge accumulation caused by contaminated oil and overdue cleaning, resulting in vibration, poor separation or frequent discharge cycles
●Water seal or interface disturbance caused by incorrect operating water, temperature or setup, resulting in oil loss to water or poor purification
●Bearing or spindle deterioration caused by wear, lubrication problems or imbalance, resulting in vibration, noise or high temperature
●Operating-water valve or discharge-mechanism failure caused by scale, seals or control faults, resulting in failure to open or close the bowl correctly
●Feed temperature, flow or heater problem caused by control or process faults, resulting in poor separation efficiency and unstable operation

Service & Maintenance

Monitor vibration, operating temperature, feed condition, discharge behavior and clean-liquid quality. Clean the bowl and disc stack using procedures that avoid damage or incorrect reassembly. Inspect spindle, bearings, seals, operating-water passages and bowl-locking parts during overhaul. Verify feed heating and process settings match the actual service. Function-test automatic sludge discharge and alarms after maintenance. Refer to the manufacturer documentation for the exact figure for bowl speed, clearances, throughput and service limits.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep bowl seals, O-rings, operating-water valve parts, bearings, drive belts or friction parts where applicable, feed-pump seals and manufacturer-recommended bowl service kits. Critical vessels may hold selected bowl components or a spare operating-water module. Confirm exact parts using the separator serial number.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Pieralisi?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #79860 · ✓ still in production