"> Mitsubishi Kakoki (MKK) Mitsubishi Kakoki SJ 700 1500l/h HFO
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 1 verified suppliers & service companies for Mitsubishi Kakoki (MKK) in the Maritime Network Find suppliers →
Mitsubishi Kakoki (MKK)

Mitsubishi Kakoki SJ 700 1500l/h HFO

Mitsubishi Kakoki (MKK) Mitsubishi Kakoki SJ 700 1500l/h HFO is listed as a Fuel Oil Separator within the Separators & Purifiers category. It is typically installed in the engine-room treatment area, connected to fuel, lubricating oil, sludge or bilge systems according to its duty. Its engineering role is to remove water and solids from shipboard liquids so downstream machinery or discharge systems receive suitably treated fluid. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.

Mitsubishi Kakoki (MKK) Mitsubishi Kakoki SJ 700 1500l/h HFO

Components & Design

Component data being added…

Technical Data

separator type fuel_oil_separator
throughput lh 1500
medium HFO
bowl speed rpm 7500

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Bowl or separation-space contamination can reduce efficiency, noticed as poor outlet quality or frequent sludge discharge
Seal-ring deterioration can cause internal or external leakage, seen as fluid loss or cross-contamination
Incorrect feed temperature, flow or backpressure can upset separation, noticed as unstable operation or poor treatment
Drive or bearing wear can increase vibration and noise, potentially causing trips
Control-water, solenoid or automation faults can disturb the operating cycle, seen as failed bowl opening/closing or repeated alarms

Service & Maintenance

Inspect bowl and disc components where applicable, seals, feed system, sludge discharge, drive condition and operating controls. Trend vibration, leakage and treated-fluid quality. Exact bowl speeds, service intervals and wear limits must be taken from manufacturer documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry seal and gasket kits, filters or strainers, solenoid/control-water parts, selected bearings and manufacturer-recommended bowl service items.
Equipment Model #79586 · ✓ still in production