"> Hamworthy (Waertsila) Hamworthy SF 600/130
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 6 verified suppliers & service companies for Hamworthy (Waertsila) in the Maritime Network Find suppliers →
Is Hamworthy (Waertsila) your company? Claim this page
Hamworthy (Waertsila)

Hamworthy SF 600/130

Hamworthy (Waertsila) Hamworthy SF 600/130 is listed as a marine fire pump (main + emergency) in the Pumps / Fire Pump (Main + Emergency) category. Equipment of this class is typically installed in the relevant machinery, cargo, ballast, fuel, cooling, bilge, fire, or service system close to the connected tanks or piping circuit. Its shipboard purpose is to move the specified shipboard liquid at the flow and pressure required by the connected system. The exact piping, electrical, control, foundation, and accessory arrangement depends on the vessel and the supplied configuration. No additional verified rating, capacity, weight, dimension, or other model-specific figure is supplied in the structured source data. Any differences from adjacent models in the same family, including rating, size, material, control, certification, or accessory differences not explicitly listed here, should be confirmed in the manufacturer documentation.

Components & Design

Component data being added…

Technical Data

pump type centrifugal
flow rate m3h 600
head m 130

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Loss of suction from empty source, closed valve, blocked strainer, air ingress, or poor priming causes low discharge pressure, cavitation noise, or no flow
●Seal or packing wear from ageing, dry running, shaft movement, or contamination produces visible leakage or loss of suction
●Bearing, coupling, shaft, impeller, rotor, or internal wear from poor lubrication, misalignment, debris, or normal service causes vibration, noise, heat, or reduced capacity
●Internal erosion, corrosion, or excessive wear reduces discharge pressure and increases recirculation or running time
●Motor, hydraulic drive, protection, or control faults from overload, electrical failure, or actuator problems result in trips, failed starting, or unstable speed

Service & Maintenance

Check suction and discharge conditions, strainers, leakage, seal area, bearings, vibration, noise, coupling alignment, driver load, valve line-up, and delivered performance. Inspect internal wear parts only to maker procedures; refer to manufacturer documentation for exact limits and settings.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Typical spares include shaft seals or packing, O-rings and gaskets, bearings, coupling elements, wear rings or internal wear parts appropriate to the pump principle, and critical driver or control items.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Hamworthy (Waertsila)?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #76573 · ✓ still in production