Thordon CompacSeries 800mm
Thordon Bearings Thordon CompacSeries 800mm is listed as a Stern Tube Bearing within the Shaft Line Equipment category. It is typically installed along the propulsion shaft line between the engine or gearbox and propeller, including stern-tube and intermediate support positions. Its engineering role is to support, seal, align or transmit propulsion torque while maintaining controlled shaft motion through the hull. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Service & Maintenance
Trend bearing temperatures, vibration, lubricant condition and seal leakage and inspect foundations and accessible shaft surfaces. Check alignment indicators after major repair or grounding events as required by vessel procedures. Clearances, wear-down limits and alignment tolerances must be taken from class-approved and manufacturer documentation.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →