"> Cryostar Cryostar Partial Reliquefaction Plant PRS
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 1 verified suppliers & service companies for Cryostar in the Maritime Network Find suppliers →
Cryostar

Cryostar Partial Reliquefaction Plant PRS

Cryostar Cryostar Partial Reliquefaction Plant PRS is listed as a Reliquefaction Plant within the Gas Carrier Cargo Systems category. It is typically installed in cargo-control spaces, pump rooms, compressor rooms or on deck as part of tanker or gas-carrier cargo handling equipment. Its engineering role is to transfer, condition, clean, monitor or calculate cargo operations while maintaining controlled pressure and safe system status. The source entry additionally records medium LNG BOG. The complete model designation should be retained when matching drawings, certificates, service information and spare parts because neighboring variants may differ in configuration even when they share the same equipment family. The exact shipboard arrangement and interfaces remain installation-specific and should be checked against the vessel’s approved drawings and equipment documentation. Where an operating value, tolerance, wear limit or setting is not explicitly stated in the source data, refer to the manufacturer documentation for the exact figure.

LNG BOG
Medium

Components & Design

Component data being added…

Technical Data

system type reliquefaction
medium LNG BOG

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Valve, seal or piping leakage can cause loss of containment, detected by pressure loss, gas detection or visible leakage
Pump, compressor or drive deterioration can reduce transfer performance, seen as low capacity, vibration or high temperature
Sensor or transmitter faults can corrupt cargo-control data and alarms
Control or interlock faults can prevent starting or safe sequence completion
Fouling, icing, deposits or contamination in cargo-service components can restrict flow and reduce efficiency

Service & Maintenance

Inspect containment, seals, valves, drives, instrumentation, shutdowns and cargo-control interfaces according to the cargo-system type. Trend vibration, pressure, temperature and alarm history where applicable. Exact operating limits and cargo compatibility requirements must follow approved cargo manuals and manufacturer documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry seals, gaskets, filters, sensors, actuator parts and manufacturer-recommended critical compressor/pump or control components compatible with the cargo service.
Equipment Model #68897 · ✓ still in production