"> Evac Evac MBR 200
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 7 verified suppliers & service companies for Evac in the Maritime Network Find suppliers →
Is Evac your company? Claim this page
Evac

Evac MBR 200

Evac Evac MBR 200 is identified in the source list as a sewage treatment plant. It is normally installed or arranged in the water-treatment or sanitary-service space. Its purpose is to treat, disinfect, soften, heat or produce water according to the listed process. The source record provides the existing record note 'Water Treatment, marine sanitary / water treatment'. The equipment is based on pumps, treatment vessels, filters, dosing, membranes, lamps, sensors and controls. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

system description membrane bioreactor STP 200 PE
person equivalent 200

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Reduced treatment performance caused by fouled filters, exhausted media, scaled membranes, aged lamps or contaminated process surfaces, resulting in poor water quality or increased pressure drop
●Dosing, regeneration or process-control failure caused by empty consumables, pump faults or control errors, resulting in incorrect treatment conditions
●Sensor or conductivity fault caused by fouling, calibration drift or wiring problems, resulting in implausible readings or alarms
●Pump or valve failure caused by wear, blockage or electrical faults, resulting in low treatment flow or inability to route water correctly
●Leakage caused by seal, housing, membrane, pressure-vessel or piping deterioration, resulting in water loss and unstable process conditions

Service & Maintenance

Inspect filters, membranes, lamps, dosing equipment, treatment vessels, pumps, valves, sensors and sample points as applicable to the installed process. Maintain hygienic conditions during opening of potable-water equipment. Trend pressure drop and water-quality indications and investigate abnormal values promptly. Verify alarms, regeneration, diversion or shutdown functions after maintenance. Store chemicals and treatment media according to approved procedures. Refer to the manufacturer documentation for the exact figure for dosing, replacement, cleaning and water-quality settings.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep filter elements, membrane or lamp components, approved treatment media, dosing-pump service parts, seals, valves, sensors and sampling consumables recommended for the installed process. Chemicals must be approved for the intended water service.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Evac?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #68631 · ✓ still in production