"> Bitzer Bitzer CSH8583-200
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
Is Bitzer your company? Claim this page
Bitzer

Bitzer CSH8583-200

Bitzer Bitzer CSH8583-200 is identified in the source list as a refrigeration compressor (piston / screw). It is normally installed or arranged in the refrigeration machinery room. Its purpose is to compress refrigerant vapor or provide the listed cooling duty. The source record provides a stated power of 200.0 kW, the stated capacity 700 kW cooling, and the existing record note 'Refrigeration, marine provision refrigeration'. The equipment is based on compression equipment, refrigeration controls, lubrication and safety devices. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

200.0 kW
Power
700 kW cooling
Capacity

Components & Design

Component data being added…

Technical Data

compressor type semi-hermetic screw
cooling capacity kw 700.0
refrigerant R-404A

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Mechanical wear caused by inadequate lubrication, contamination or long service, resulting in rising vibration, noise or temperature
●Seal or gasket deterioration caused by wear, corrosion or misalignment, resulting in visible leakage or loss of process containment
●Flow restriction, cavitation or fouling caused by blocked passages or unsuitable operating conditions, resulting in reduced capacity and unstable performance
●Motor, coupling or drive failure caused by electrical faults, misalignment or overload, resulting in trips, abnormal current or inability to reach normal speed
●Sensor, control or protection failure caused by wiring, calibration or electronics faults, resulting in alarms, incorrect control response or shutdown

Service & Maintenance

Inspect bearings, lubrication, seals, couplings, foundations, process connections and protective devices. Trend vibration, temperature, pressure, flow and motor load where available and investigate deterioration from the established normal condition. Check for leakage, corrosion, fouling and abnormal mechanical contact. Function-test local and remote controls, alarms and shutdowns after maintenance. Maintain cleanliness during opening and reassembly. Refer to the manufacturer documentation for the exact figure for clearances, limits, settings and overhaul criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep model-correct seals, gaskets, bearings, filters or strainers, coupling parts, sensors and manufacturer-recommended wear components. Critical installations may justify a rotating assembly, motor or control module according to redundancy. Confirm all parts against the exact model and serial number.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Bitzer?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #68587 · ✓ still in production