RWO SKIT/S 1.0 m³/h
RWO RWO SKIT/S 1.0 m³/h — Oily Water Separator. It is normally installed in the engine-room bilge-treatment area between bilge holding arrangements and the approved recirculation or discharge piping. Its primary purpose is to remove oil from contaminated bilge water before any permitted overboard discharge. Unlike ordinary settling equipment, an approved OWS is integrated with oil-content monitoring and automatic stopping or recirculation. The model designation identifies the listed configuration, but no additional meaning is inferred from the model code beyond the information supplied in the source record. For exact ratings, dimensions, settings, capacities, materials and variant-specific limits, refer to the manufacturer documentation for the exact figure.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Service & Maintenance
Inspect separation stages, filters, pumps, monitor sample lines, automatic stopping devices and overboard valve arrangements. Verify that the approved treatment route cannot be bypassed and review operating records where required. Clean and check the oil-content monitor according to the approved procedure. Refer to the manufacturer documentation for the exact figure for flow, pressure and calibration criteria.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →