OceanSphereENGINES
Library› Electrical› Cable & Wiring› Power Cable (0.6/1 kV)› Tele-Fonika Kable NKOXSekw 0,6/1 kV, NKOXSekw EMC 0,6/1 kV
Tele-Fonika Kable

NKOXSekw 0,6/1 kV, NKOXSekw EMC 0,6/1 kV

Power Cable (0.6/1 kV) · Cable & Wiring

Class-certified type (DNV register) · technical data sheet not yet verified​​⁠‌‍​‌⁠⁠⁠‌‌‌​‌⁠​​‍​

The NKOXSekw 0,6/1 kV and NKOXSekw EMC 0,6/1 kV from Tele-Fonika Kable S.A. are shipboard power cables rated 0.6/1 kV, covered by DNV certificate TAE00004HH. The EMC version is intended for installations where electromagnetic screening is needed. The cables are routed on cable trays and through penetrations between generators, switchboards and consumers on board.

Specifications

Technical data.reference — unverified

Do you have the manufacturer datasheet for this model? Send it with the enquiry form — we check it and name the source.

Max. conductor operating temperature+90oC °C
Max. short-circuit conductor temperature+250oC °C
Inspection

Inspector Detail

Common issues

  • Insulation degradation from prolonged heat exposure near hot machinery surfaces
  • Mechanical damage during installation from excessive bend radius or crushing
  • Moisture ingress at glands or terminations reducing insulation resistance
  • Chafing where the cable is not properly clipped or supported along its route
  • Poor termination workmanship causing partial discharge at medium-voltage joints
  • Other cables laid across the route reducing its fire-survival protection

Inspection checklist

  • Visual condition of the outer sheath along the full route
  • Cable support/clipping and bend radius compliance
  • Gland and termination condition at both the generator and switchboard ends
  • Insulation resistance (megger) test
  • Continuity and earth continuity check
  • Fire-resistant/circuit-integrity route protection intact, with no other cables encroaching on its clearance
  • Cable identification/labeling at both ends

Service intervals

Visual route inspectionannually, or per the periodic electrical survey
Insulation resistance testannually
Termination/gland inspectionannually
Route protection/clearance checkat each periodic fire safety inspection

Typical intervals for this design class, not the manufacturer’s figures for your model. The manufacturer’s manual is binding.

Typical wear limits

Insulation resistancetypically expected above 1 M ohm, or the applicable IEC/class minimum for MV power cables in service - confirm against the vessel's electrical survey acceptance criteria
Outer sheath damageany breach exposing the armour or insulation should be assessed against the maker's repair guidance before the cable is returned to service
Termination temperature/conditionany discolouration or heat damage at a termination indicates a poor connection and should be reworked - confirm against the maker's termination instructions

Ranges are typical for this design class. Always confirm against the manufacturer documentation for your serial number.

Critical spares

  • Matching fire-resistant/circuit-integrity MV cable of the same cross-section and voltage class
  • Matching MV cable glands
  • MV termination/jointing kit
  • Cable lugs of the correct rating
  • Cable support clips/cleats matching the installation

Safety

  • Medium-voltage shock hazard - proof of dead, isolation, and earthing required before any work (permit to work)
  • This cable forms part of the emergency power fire-survival circuit - damage or unauthorised route changes can compromise emergency generator availability during a fire
  • MV terminations should only be made or tested by qualified personnel
  • A fire-resistant cable installed on an unprotected or incorrect route may still fail in a fire if not installed as approved

Class survey

Note: this catalog entry's 'typ' field ('Emergency Generator Set') does not match the actual product - this is a fire-resistant medium-voltage power cable used to connect an emergency generator to the distribution system, not the generator set itself; the content above addresses the cable. Class surveyors verify the emergency source cable route/rating supports SOLAS emergency power availability requirements and check insulation resistance records at periodic survey.

Estimated lifetime: Marine fire-resistant MV power cables of this type are typically designed for the vessel's operating life, commonly in the order of 20-25+ years, provided mechanical damage, moisture ingress, and thermal exposure limits are avoided - confirm against the maker's documentation.

Classification

DNV type approval

Listed in the DNV Approval Finder at the time we recorded it. The certificate is issued by DNV, not by us; check its current status at DNV.

CertificateTAE00004HH
Open the certificate at DNV
Need this part?

Request a quote for this model.

Free of charge — send us your request for Tele-Fonika Kable equipment. Our team checks it and replies by e-mail.

For marine equipment hardly any maker or authorised dealer will name a price while the vessel is unknown. With the vessel details, availability and price can be settled faster; without them we may have to ask first, which costs a few days. If you are not allowed to name the vessel, a photo of the rating plate is enough — attach it below or send it as a reply to our confirmation e-mail.

Your contact details are not published. No account required.
Related models

Also in Power Cable (0.6/1 kV).

Other models of the same equipment type, Tele-Fonika Kable first.

By manufacturer Draka/PrysmianPrysmianHelkama BicaNexansLS CableEland CablesNKT MarineTMC MarineTKF/TKDUNIKAStuder CablesSEIMIElettrotek KabelTMC CableAmerCableAll manufacturersSpare parts by equipmentNew here? Create a free account Can't read the plate? Try the nameplate scanner More like NKOXSekw 0,6/1 kV, NKOXSekw EMC 0,6/1 kV
More than the data sheet shows

We answer by e-mail, never with an automatic reply.

Tell us what you need for this Tele-Fonika Kable NKOXSekw 0,6/1 kV, NKOXSekw EMC 0,6/1 kV — a part, a service call, a second opinion. Are you Tele-Fonika Kable? Claim this brand page.

Service engineer? Write the day report for this NKOXSekw 0,6/1 kV, NKOXSekw EMC 0,6/1 kV in OceanSphere Work — photos, hours and parts, as a PDF for the owner. Try it free for 14 days →

Frequently asked

Questions that come up with this equipment.

Is this model's data free?

Yes. Specifications, documents and service notes for this model are readable without an account. An account adds saved searches and requests, nothing is taken away.

Can you find a part for this exact model?

Yes. Tell us the manufacturer, the model and what you need — a person reads every request and replies by e-mail.

The specifications look wrong — what now?

Send us the nameplate or the correct value. We check it against the manufacturer datasheet or class-society record and update the page.