"> Kongsberg Maritime AS Signal Converter Programmable
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 5 verified suppliers & service companies for Kongsberg Maritime AS in the Maritime Network Find suppliers →
Is Kongsberg Maritime AS your company? Claim this page
Kongsberg Maritime AS

Signal Converter Programmable

Signal Converter Programmable by Kongsberg Maritime AS is a programmable signal-conversion module used to adapt field instrumentation signals to the automation system. It is normally installed at instrument or automation cabinets between field transmitters and control-system I/O and is connected to the vessel's alarm, monitoring or control architecture. The device converts a physical condition or field signal into information that can be supervised, alarmed or used by automation logic. Correct operation depends on sound sensor installation, stable power, intact cabling and valid calibration or configuration. Unlike a simple fixed isolator, its conversion behaviour is configured for the particular input and output signal. For any model-specific range, wiring or alarm limit, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

Element type Code
Pt100 U
Pt1000 M
NiCr/NiAl K
Fe/CuNi J
Range °C Code
-200 to +200 10
-50 to +50 11
0 to +160 12
0 to +300 13
0 to +600 14
0 to +100 15
-50 to +100 16
0 to +900 17
0 to +800 18
Brochure Company brochure
Data sheet Temperature Transmitter GN-11

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Open-circuit, short-circuit or damaged field wiring, causing bad-quality indication, fixed value or sensor-fault alarm
●Calibration drift or sensor ageing, producing a reading that disagrees with local or redundant instrumentation
●Moisture, vibration or connector corrosion, causing intermittent signals and nuisance alarms
●Power-supply or module failure, resulting in loss of one or more monitored channels
●Configuration, scaling or channel-assignment error after replacement, causing plausible but incorrect displayed values

Service & Maintenance

Compare displayed values with an independent reference or redundant sensor where possible, inspect cabling and terminals, and verify sensor mounting and process contact. Test alarm initiation and channel-failure supervision without defeating machinery protection. After replacing a module or sensor, confirm scaling, tag identity, alarm limits and configuration against the approved vessel documentation. Survey attention is on reliable alarm indication, traceable testing and any safety-critical shutdown interfaces; refer to the manufacturer documentation for the exact figure.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry compatible sensors or modules, connector/terminal items, control-power fuses and any approved signal-conditioning components used by the installed channel. Keep current configuration backups and calibration information for programmable or system-level modules.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Kongsberg Maritime AS?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #153085 · ✓ still in production