Alarm And Control System Kd 30
Alarm And Control System Kd 30 by Kongsberg Maritime AS is a legacy marine alarm-and-control system designated KD 30. It is normally installed at engine-control rooms, bridge interfaces and machinery automation cabinets and is connected to the vessel's alarm, monitoring or control architecture. The device converts a physical condition or field signal into information that can be supervised, alarmed or used by automation logic. Correct operation depends on sound sensor installation, stable power, intact cabling and valid calibration or configuration. It is a complete legacy control-system platform, not merely an individual sensor or signal module. For any model-specific range, wiring or alarm limit, refer to the manufacturer documentation for the exact figure.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Service & Maintenance
Compare displayed values with an independent reference or redundant sensor where possible, inspect cabling and terminals, and verify sensor mounting and process contact. Test alarm initiation and channel-failure supervision without defeating machinery protection. After replacing a module or sensor, confirm scaling, tag identity, alarm limits and configuration against the approved vessel documentation. Survey attention is on reliable alarm indication, traceable testing and any safety-critical shutdown interfaces; refer to the manufacturer documentation for the exact figure.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →