XM-10
Sasakura XM-10 — Marine freshwater generation via tubular heat exchanger evaporation.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Verify vacuum gauge reading minimum 90% vacuum; standard vacuum generation time approximately 10 minutes from cold start
Inspect heat exchanger plates for mineral deposits (calcium carbonate, magnesium hydroxide, calcium sulphate) via demister removal; perform chemical descaling per manufacturer schedule based on fouling rate
Monitor salinometer reading; check ejector nozzle condition and brine extraction pump operation; ensure brine level is maintained correctly
Remove separator shell man-hole cover and heat exchanger bottom cover for visual inspection; verify Neoprene coating integrity; check for exfoliation; inspect condenser cooling tubes for sludge fouling
Check thermometer on separator shell after 15-30 minutes of steady operation; maintain lowest safe evaporation temperature to minimize scale formation risk without compromising salinity
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →