BTVE
Seepex BTVE — Open Hopper Pump with Robust Full Screw - Dewatered sludge and semi-solid materials (DM content up to 30%).
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Visual inspection of rotor and stator surfaces for scratches, pitting, or wear marks. Inspect every 1,000-5,000 operating hours. Critical: new rotor in worn stator will fail immediately.
Weekly leak inspection of seal interface. Check seal faces and O-rings for damage. Look for visible weeping, misting, or spray at seal location.
Monitor bearing end-play and temperature during operation. Check monthly for bearing temperature elevation and lubrication oil level. Maximum operating temperature up to 180°C.
Weekly flow rate measurement at rated pressure and motor RPM/amperage. Verify pump discharge pressure against pump curve. Check for pressure spikes or cavitation.
Pre-start verification of coupling connection and attachment. Monitor for increased vibration or noise during operation. Check universal joint bushing wear and grease condition.
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →