ALLFUEL AFM 10
Allweiler ALLFUEL AFM 10 — Fuel transfer, booster pump, magnetic coupling.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Visual inspection for external leaks at shaft seal area; pressure test inlet/outlet; check seal surface for scoring or discoloration
Measure hardness of spindles (must remain within specification); inspect polished surfaces for scratches/pitting using 10x magnification; check for particles in fluid
Run differential pressure test: measure inlet vs. discharge pressure during operation; compare against max ratings (e.g., ALLFUEL max 40 bar differential); trending over time
Lab analysis of fluid: viscosity (target range per model, e.g., AFI max 1,750 mm²/s); particle count ISO 4406; temperature monitoring (max 150°C for AFI/ALLFUEL)
Acoustic monitoring for high-frequency noise; ultrasonic testing of rotor surfaces; check inlet pressure (max inlet per model); verify pump alignment and mounting bolts
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →