NX 418
Alfa Laval NX 418 — Sludge and wastewater dewatering.
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Clean and inspect all operating water nozzles regularly; remove accumulated sludge using soft iron wire; verify nozzle holes are clear of deposits
Replace main and internal bearings every 15,000 operating hours; perform weekly lubrication checks; monitor for unusual noise or vibration during operation
Inspect bowl seals and gaskets for cracks and wear; perform seal replacement on schedule depending on application (every few weeks for abrasive fluids to every few months for benign applications); check for liquid leakage
Inspect regularly for corrosion damage; inspect frequently if process liquid is erosive; contact manufacturer if erosion damage exceeds 1.0 mm depth; check conveyor for wear
Check for dirt and lime deposits in sludge discharge mechanism; thoroughly clean discharge parts; verify sludge ports for cracks in rotating parts and bowl wall pillars; test discharge operation
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →