CPS-3.2E + EMB
Facet CPS-3.2E + EMB — Bilgenwasser-Separator mit Keramikmembran (5ppm Effluent).
Components & Design
Component data being added…
Technical Data
🤖 Ask about this model
One free question — answered like a marine engineer. No account needed.
Common failures & inspection points
Perform visual inspection of EBM/EMB ceramic membranes for cracks, pores or wear; replacement recommended after approximately 3–6 months of operation or upon visible wear
Coalescer plate stack (FACET Mpak) to be rinsed regularly to remove fouling and oil deposits; chemicals not required
Check vertical section of effluent line near separator outlet; sampling point must be present and unobstructed for oil content measurements
Inspect all flange gaskets (DN connections), pneumatic valve gaskets and BSP outlet connections for oil or water leaks; ensure gasket condition
Perform functional test of fully automatic control; check oil content sensor calibration; test alarm and shutdown functions; verify power supply 380/440 V at 50/60 Hz
Type-general inspection and maintenance points for this equipment category — not model-specific.
Suppliers & Spare Parts
Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.
📄 Request sourcing links & documentsCases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.
Start free trial →Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.
Maritime Network →