"> Palfinger Marine Palfinger Marine DC 50t/40m-C
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 10 verified suppliers & service companies for Palfinger Marine in the Maritime Network Find suppliers →
Is Palfinger Marine your company? Claim this page
Palfinger Marine

Palfinger Marine DC 50t/40m-C

Palfinger Marine Palfinger Marine DC 50t/40m-C is identified in the source list as a deck crane. It is normally installed or arranged in the reinforced deck pedestal or crane foundation. Its purpose is to lift and position stores, cargo or offshore equipment. The source record provides the existing record note '50 t lifting capacity'. The equipment is based on hoisting, luffing, slewing, brakes, controls and structural load paths. The exact model designation distinguishes the installed configuration from neighboring variants in the same category; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

lifting capacity t 50
boom reach m 40

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Wire-rope, chain, roller or line-contact wear caused by loaded movement, corrosion or poor lubrication, resulting in visible damage, rough operation or accelerated rope wear
●Brake, locking or clutch deterioration caused by repeated loading or contamination, resulting in poor holding or excessive travel
●Hydraulic or electric drive failure caused by leakage, motor faults or control problems, resulting in slow, weak or unavailable movement
●Bearing, pin, hinge or structural wear caused by cyclic loading and corrosion, resulting in play, vibration, misalignment or abnormal noise
●Limit, interlock or control-system fault caused by sensor, wiring or calibration problems, resulting in inhibited movement, alarms or loss of protective functions

Service & Maintenance

Inspect load-bearing structure, brakes, locks, ropes or chains, rollers or sheaves, pins, bearings, drives, controls and foundations as applicable. Lubricate specified points and inspect hydraulic hoses or electrical equipment according to drive type. Function-test local and remote controls, limit devices, emergency stops and interlocks using approved procedures. Examine high-load welds and line-contact areas for corrosion, cracking, deformation or sharp edges. Keep personnel clear of suspended loads and snap-back or pinch zones during tests. Refer to the manufacturer documentation for the exact figure for load tests, allowable wear, brake settings and inspection criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep brake or locking service parts, seals, bearings, hydraulic hose or valve consumables, control switches, sensors and manufacturer-recommended rope, roller or sheave wear parts. Heavy structural, gear and load-bearing components are normally strategic spares.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for Palfinger Marine?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #137154 · ✓ still in production