"> R.M. Young R.M. Young Hygrometer-C
OceanSphere
Engines
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 102 verified suppliers & service companies for R.M. Young in the Maritime Network Find suppliers →
Is R.M. Young your company? Claim this page
R.M. Young

R.M. Young Hygrometer-C

R.M. Young R.M. Young Hygrometer-C is identified in the source list as a marine weather station or anemometer. It is installed on the bridge and at the associated antenna, transducer, camera or sensor location, with data distributed to connected ship systems as required. Its purpose is to provide wind or weather-related measurements to bridge personnel and connected systems. The source record provides no additional model-specific operating figure beyond the listed designation and category. The exact sensor set, recording functions, data interfaces, approval status and redundancy depend on the installed model. The exact model designation distinguishes sensing, recording or communication capability from neighboring bridge equipment; refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

type Hygrometer
marine grade True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

●Sensor fouling, bearing wear, icing, salt contamination or electronics failure, resulting in missing, sluggish or implausible weather data
●Power-supply failure caused by breaker, converter or wiring faults, resulting in loss of the equipment or repeated restarts
●Network or interface failure caused by damaged cabling, port faults or configuration changes, resulting in loss of data to connected systems
●Display, processor or control failure caused by hardware or software faults, resulting in frozen indications, alarms or unavailable functions
●Incorrect configuration or time, position or sensor input caused by setup or upstream faults, resulting in misleading or incomplete information

Service & Maintenance

Inspect sensors, antennas, transducers, cameras, cabling, power supplies and network interfaces applicable to the installed equipment. Compare displayed information with independent references where possible and investigate recurring alarms or missing channels. Verify required outputs to other bridge systems and preserve configuration before approved software or hardware maintenance. Clean exposed sensors and optical surfaces without damaging coatings or seals. Check backup power or recording arrangements where applicable. Refer to the manufacturer documentation for the exact figure for test, calibration, update and recovery procedures.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep fuses, selected power-supply and interface modules, cables or connectors, storage media where applicable and manufacturer-recommended sensor or electronic spares. Replacement core units must remain compatible with the approved bridge installation. Preserve configuration and recorded setup data.
Working on this unit?
Log hours, photos and findings into an invoice-ready service report — OceanSphere Marine, 14-day free trial.
Need a service partner for R.M. Young?
114,000+ shipyards, suppliers and service companies in the Maritime Network directory.
Equipment Model #136395 · ✓ still in production