"> MSM Marine MSM Marine NUC 5nm-C
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
MSM Marine

MSM Marine NUC 5nm-C

MSM Marine MSM Marine NUC 5nm-C is listed in the source as a marine Navigation Light within the Signaling & Visual group. Equipment of this type is typically installed at the mast, bridge wing, deck or signaling station where the required light or visual signal has an unobstructed field of view. Its primary duty is visual navigation or signaling duty associated with the Navigation Light, and it depends on the light source, optical housing, power supply, mounting alignment and control or monitoring circuit remaining serviceable. Neighboring variants can differ in rating, size, interface, approval basis or arrangement, so the complete model designation and actual nameplate data are important for identification. It normally interfaces with navigation-light panels or local controls, ship power, cabling, mounting structures and alarm monitoring where fitted. For any exact capacity, pressure, voltage, tolerance, wear limit or setting not stated in the source, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

light type NUC
visibility nm 5
colreg compliant True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Light-source failure caused by ageing or electronic faults can produce complete loss of illumination or a lamp-failure alarm
Lens contamination, salt deposits or water ingress can reduce visible output and may show as dim or uneven light
Corroded terminals or damaged cabling caused by exposure can create intermittent operation, voltage loss or monitoring alarms
Mounting damage or misalignment caused by vibration or impact can alter the intended sector or aiming direction
Control-panel or monitoring-circuit faults caused by relay, fuse or sensor problems can give false status or prevent switching

Service & Maintenance

Inspect lens condition, seals, mounting, sector or aiming arrangement, cable glands and corrosion. Test normal and backup supply or alarm monitoring according to the vessel's approved procedure. Refer to manufacturer and statutory documentation for exact luminous, range and sector requirements.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry approved replacement light modules or lamps where applicable, seals, fuses, connectors, control relays and mounting hardware matching the certified installation.
Equipment Model #136145 · ✓ still in production