"> Cobham SATCOM Cobham SATCOM VSAT Ka-Band 100cm-C
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 2 verified suppliers & service companies for Cobham SATCOM in the Maritime Network Find suppliers →
Cobham SATCOM

Cobham SATCOM VSAT Ka-Band 100cm-C

Cobham SATCOM Cobham SATCOM VSAT Ka-Band 100cm-C is listed as a marine communications and safety radio unit in the GMDSS / Inmarsat Terminal category. Equipment of this class is typically installed on the bridge, in the GMDSS console, or at an associated antenna and transceiver location. Its shipboard purpose is to support ship-to-ship, ship-to-shore, distress, safety, navigational, or operational communications according to its configured function. The exact piping, electrical, control, foundation, and accessory arrangement depends on the vessel and the supplied configuration. No additional verified rating, capacity, weight, dimension, or other model-specific figure is supplied in the structured source data. Any differences from adjacent models in the same family, including rating, size, material, control, certification, or accessory differences not explicitly listed here, should be confirmed in the manufacturer documentation.

Components & Design

Component data being added…

Technical Data

antenna diameter cm 100
band Ka-Band
stabilized True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Loss of primary or reserve power from a tripped breaker, failed power unit, loose connection, or depleted battery causes a dead unit, rebooting, or failed transmission
Antenna, feeder, connector, or matching faults from corrosion, water ingress, or physical damage cause poor range or weak received signals
Control-panel, display, keypad, or software faults prevent channel selection, message handling, or operator input
Interface or position-data failure from wiring, configuration, or sensor faults removes position or connected-system data
Internal transmitter, receiver, or modem faults from component ageing or overheating cause intermittent communication, alarms, or inability to establish a link

Service & Maintenance

Verify primary and reserve power, antenna and feeder condition, permitted distress/safety self-tests, interfaces, audio quality, time and position inputs, and logged faults. Regulatory tests and adjustments must follow vessel radio procedures and manufacturer documentation.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Carry model-specific fuses, approved power-supply items, handset or microphone accessories where relevant, connector and sealing items, and critical interface or antenna components recommended by the manufacturer.
Equipment Model #135877 · ✓ still in production