"> NAFFCO Marine NAFFCO Deluge Marine
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 1 verified suppliers & service companies for NAFFCO Marine in the Maritime Network Find suppliers →
NAFFCO Marine

NAFFCO Deluge Marine

NAFFCO Marine NAFFCO Deluge Marine is a shipboard unit in the Fixed Fire Suppression group, classified in the source as Deluge/Sprinkler System. It is normally installed in machinery spaces, cargo/vehicle areas or protected compartments with pumps, cylinders or agent storage located in designated fire-safety spaces. Its primary duty is to suppress or extinguish fire using water mist, foam, deluge/sprinkler or clean-agent discharge appropriate to the protected hazard. In service it interfaces with pumps or agent cylinders, distribution piping, section valves, detection/release controls, alarms and ventilation/shutdown interlocks. Compared with neighboring entries in the same product family, this record is the exact NAFFCO Marine NAFFCO Deluge Marine variant; the model designation should be retained unchanged when matching onboard documentation and spares. For exact limits, settings, test values and approved maintenance criteria, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Blocked nozzles or piping from contamination/corrosion, typically indicated by poor test flow or impaired coverage
Pump, cylinder or pressure loss, typically indicated by low pressure, failed readiness check or discharge alarm
Valve/actuator sticking, typically indicated by section fails to open or close during testing
Detection/release control fault, typically indicated by failed automatic/manual release or incorrect indication
Leakage/corrosion in distribution piping, typically indicated by pressure loss, visible leaks or failed integrity test

Service & Maintenance

Inspect agent/pump readiness, valves, nozzles, piping, release controls, alarms and shutdown interlocks; flow, pressure and discharge tests must follow approved fire-system procedures and exact manufacturer criteria.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Keep nozzle caps/filters, valve and actuator seal kits, release solenoids, pressure switches, detector/interface components and approved pump service parts.
Equipment Model #130141 · ✓ still in production