"> Ocean Signal E100
⚓ Working on this equipment?
Ask the AI troubleshooter, log your hours on board and turn them into invoice-ready service reports — for this exact model.
Start free — 14 days →
No credit card required
🔧 12 verified suppliers & service companies for Ocean Signal in the Maritime Network Find suppliers →
Ocean Signal

E100

The Ocean Signal E100 is a 406 MHz emergency position-indicating radio beacon. It is normally installed externally near the bridge or survival-craft area in a manual or float-free mounting. It is designed for satellite distress alerting after abandonment or serious casualty. The operating principle relies on transmission of a registered distress identity and, where fitted, position/homing information. The supplied entry gives no additional verified capacity, pressure, power or dimensional figure for this model. Compared with neighbouring models, the relevant differences are Category I/II, float-free/manual mounting, GNSS and homing features; these must be confirmed from the installed documentation rather than inferred from the model designation alone. Service and survey attention should concentrate on registration, battery, self-test, casing/antenna, bracket and hydrostatic release where fitted. For exact ratings, dimensions, tolerances, test limits and model-specific settings, refer to the manufacturer documentation for the exact figure.

Components & Design

Component data being added…

Technical Data

gps integrated True

🤖 Ask about this model

One free question — answered like a marine engineer. No account needed.

Common failures & inspection points

Battery depletion or expiry caused by age or storage conditions, noticed from the service marking or failed self-test
Antenna or casing damage caused by impact, weather or poor stowage, noticed visually or through failed self-test
Activation mechanism failure caused by corrosion or mechanical damage, noticed during approved testing
Incorrect registration, identity or pairing caused by administrative/configuration error, noticed when equipment data do not match vessel records
Water ingress caused by damaged seals, noticed as corrosion, fogging or failed test

Service & Maintenance

Check battery/service expiry, approved self-test, casing, antenna, activation arrangement and identification/registration. Verify mounting, lanyard, pole or hydrostatic-release arrangement where applicable and ensure deployment is unobstructed. Do not generate a live distress transmission during routine inspection unless an authorized test procedure specifically requires it.

Suppliers & Spare Parts

Direct links to manufacturer, datasheet, spare-parts portal and dealers — request access below.

📄 Request sourcing links & documents
🛠 Manage this equipment in your fleet

Cases, daily reports, timesheets and AI troubleshooting in the OceanSphere Marine app — free for 14 days.

Start free trial →
🔎 Suppliers & service for this equipment

Find manufacturers, repair shops and spare-part dealers in the Maritime Network — our global company directory.

Maritime Network →

Replacement Parts

Internal repair is normally an authorized-service task. Carry only manufacturer-approved external mounting, lanyard, bracket, pole or hydrostatic-release parts where shipboard replacement is permitted, and schedule battery/service replacement before expiry.
Equipment Model #129868 · ✓ still in production